Sub 12 means from stage one to two heat transfer

Assignment Help Civil Engineering
Reference no: EM13557072

Sub 12 means from stage one to two. Heat transfer (Qsub12) occurs to a fluid of mass m whose volume increases at a constant pressure of 21 bar. Assume that the fluid is air (Csubv=0.718 kJ/kg *K and R=0.287 kJ/kg*K) and that Tsub1=725K and Tsub2=1100K. Assume that the fluid expansion is fully resisted. Determine in kJ/kg

a) Wsub12 (or Wsub12/m)

b)Deltau (or deltaU/m)

c)qsub12 (or Qsub12/m)

Reference no: EM13557072

Questions Cloud

Determine the corresponding increase in water temperature : Water flows over a waterfall that is 60m high. Assuming that all of the potential energy of the water at the top of the fall is converted to an increase in internal energy at the bottom of the fall
Calculate the change in length of a 30m measuring tape made : Calculate the change in length of a 30m measuring tape made of steel when its temperature changes by 84 F. The coefficient of thermal expansion for steel is x = 3.1 x 10^-6 per C
Determine the temperature rise : A 45 W electric mixer is operated for 5 minutes while mixing a 2 kg shake. Assume Csubv=4200 J/kg-K for the liquid. Determine the temperature rise (in degrees C) of the milk shake.
Neglecting drive train losses what is the average power : A cyclist rides up a local mountain at an average speed of 11 mph. The road has an average grade of 5.5%. The cyclist and her bike have a combined mass of 75 kg. The force from road drag is 2.5 N and the aerodynamic drag (in Newtons)
Sub 12 means from stage one to two heat transfer : Sub 12 means from stage one to two. Heat transfer (Qsub12) occurs to a fluid of mass m whose volume increases at a constant pressure of 21 bar. Assume that the fluid is air (Csubv=0.718 kJ/kg *K and R=0.287 kJ/kg*K) and that Tsub1=725K and Tsub2=1100..
What is the change in internal energy of the system : What is the change in internal energy of the system? Assume the displacement work in a (fully resisted) constant pressure process is given by (*sub 12 means from stage 1 to 2) Wsub12=p(Vsub2-Vsub1).
What should the spring stiffness be if the spring : A 2 kg block is projected up a frictionless plane with and initial speed of 8 m/s. The plane is inclined upward at 30°. If the block travels 5 m before striking a linear spring, what should the spring stiffness be if the spring compression is to be l..
What is the concentration of bod in the river-wastewater mix : Compare the monolithic approach, the layered approach, and the microkernel approach in terms of degree of difficulty to debug, portability, efficiency, and degree of structure.
How much heat energy is radiatred from each of the disk : Given the heat transfer of the disk rotor is 120 W/m2/K, how much heat energy is radiatred from each of the disk rotors when the ambient air temperature is 30 C

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the level of the service of this compound-grade

If the peak-hour factor is .90 and all of the drivers are regular users, what is the level of the service of this compound-grade freeway segment?

  Calculate maximum compressive and maximum tensile stresses

Consider a wide flange steel beam of size W10x60 subjected to a negative bending moment of 24 kip ft. Calculate the maximum compressive and maximum tensile stresses and indicate where the stress will be tensile and where compressive.

  Derive an expression relating effluent concentration

Derive an expression relating effluent concentration to influent concentration, hydraulic residence time, and the reaction rate constant for a zero order reaction in a CSTR at stead-state.

  What are the problems associated with bridge widening method

In bridge widening projects, the method of stitching is normally employed for connecting existing deck to the new deck. What are the problems associated with this method in terms of shrinkage of concrete

  Estimate the vertical hydraulic conductivity using the heads

Write Darcy's equation in 2-D. There are three piezometers in an unconfined sand aquifer as shown below. The head measurements at A = 104.56 ft, B = 104.53 ft, C = 103.42 ft. The rate of recharge here is estimated to be 1.25 ft/yr.

  Cylindrical pressure vessel with hemispherical ends

A cylindrical pressure vessel with hemispherical ends has a 2.5-m radius and a 5-mm wall thickness. It contains a gas with pressure pi = 6×10 5 Pa and the outer wall is subjected to atmospheric pressure p 0 = 1 × 10 5 Pa.

  Determine station of point where superelevation runoff begin

The station of the PC is 20+00. Determine the station of the point where th superelevation runoff begins, the station whe the tangent runoff begins and the station where the curve is fully superelevated if the design superelevation is 6%

  What is the discharge through the pipe for a water

A fire hydrant is supplied through a 6 inch cast iron pipe of 16,000 feet length. The total drop in pressure is limited to 35 psi. What is the discharge through the pipe for a water temperature of 80°F

  Calculate the r-value for the wall assembly

Calculate the R-value for the wall assembly. This calculation should be done by hand, on engineering paper, and handed in during class (or scanned and submitted online).

  Determine the initial speed of the ball and the angle

From a videotape, it was observed that a player kicked a football 126 {\rm ft} during a measured time of 3 seconds. Determine the initial speed of the ball and the angle(theta) at which it was kicked

  Determine what is the economic life of the challenger

The initial investment is $12,000 , there is no annual maintenance cost for the first 3 years , however , it will be $2,000 in each of years four and five , and then $4,500 in the sixth year and increasing by $2,500 each year thereafter .

  What is the max amount of benzene that the company can

A company near City X want's to know how much benzene they can release into River Y. City Z is 85.5 miles downstream from City X. City Z doesn't want to have Benzene levels higher than 0.0000015 g/L.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd