### Sketch process on p-v diagram clearly labeling final states

Assignment Help Civil Engineering
##### Reference no: EM13297128

5 Kg of water at 1.2 MPa, 120oC is contained in a frictionless piston-cylinder device. The water is heated until its temperature reaches 250oC.
a) a)Determine the work performed in kJ
b) b)Determine the amount of heat (Q) added in kJ.
c) c)Sketch this process on a P-v diagram clearly labeling the initial (1) and final (2) states.

### Write a Review

#### Explain will the vertical curve meet minimum ssd standards

A particular crest vertical curve has long been criticized as being unsafe. Its length is 400 ft. The prevailing speed on the crest vertical curve is 50 mph. In its present condition, its tangent grades are +2% and -3%.

#### Use the bernoulli equation

Use the Bernoulli equation to describe how this manometer can be used to measure the flow rate through the meter.

#### Define soda ash and quicklime

Soda Ash and QuickLime, A lime-soda softening plant treats a flow of 150 MGD, and the water has 86mg/l Ca2+, 35 mg/L Mg2+, 299 mg/L HCO3- and 6mg/l CO2.

#### Determine the slenderness ratio

Determine the slenderness ratio of a 5 m column with built in ends if its cross- section is (a) circular with a radius of 40mm and (b) 50 mm square. Use the concept of effective length.

#### Determine the velocity v2 of the particle

The motion occurs in the horizontal x-y plane. Determine the velocity V2 of the particle at the end of the 3-s interval.

#### Determine the practical moment strength phi-msubn for steel

determine the practical moment strength phi x Msubn for a rectangular reinforced concrete cross section having a width (b of 13 in.) and an effective depth (d of 24 in.) The tension reinforcing steel is four no# 8 bars.

#### Design a curve for the highway by computing the radius

The PI is at station 250+50, the design speed is 65mi/h, and a maximum superelevation of 0.07 ft/ft is to be used. If the central angle of the curve is 38 degrees, design a curve for the highway by computing the radius and stationing of PC and PT.

#### Determine the actual field weight required to mix a 4 bag

Determine the actual field weight required to mix a 4 bag mix using the mix proportions given below. The excess moisture contet of the sand is 6% and that of the gravel is 2% Component Weight ..

#### Identify the forces that work against success of cladding

Identify the forces that work against the success of cladding systems in keeping the elements out.

#### Determine the required pumping rate

Determine the required pumping rate. the aquifer has T= 1600 m2/day and the wells each have radius of influence of 600m.

#### Define what are the quantitative measures of reliability

What are the quantitative measures of reliability (discuss measures for hardware, software, personnel, facilities, and data)?

#### Establishing a horizontal distance

A tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. What measurements should be laid out to establish a horizontal distance of 682.25ft?