Reference no: EM131276626
Assignment
Objectives
Explain the bid and proposal process to include preparing RFP requirements, preparing a proposal, responding to and evaluating bids, and contract formation
400 words
Now that a decision has been made to outsource, there are a few steps before the work commences. First, it is recommended that at least 3 different vendors are solicited with a request for proposal (RFP). This RFP should include scope of the project and proposed time, along with other important sections. The statement of work will thoroughly outline all of the work you are requesting of the selected RFP. You will be researching templates for both the RFP and the statement of work that work best for your selected project.
Primary Task Response: Within the Discussion Board area, write 350-600 words that respond to the following questions with your thoughts, ideas, and comments. This will be the foundation for future discussions by your classmates. Be substantive and clear, and use examples to reinforce your ideas.
Research at least 2 sources (which may include your textbook) to support your response.
•Research and present at least 2 templates for request for proposal (RFP) that most closely align with your Key Assignment project.
•Research and present at least 2 templates for statement of work (SOW) that most closely aligns with your Key Assignment project.
•Research and present at least 2 templates for procurement contract award that most closely aligns with your Key Assignment project.
•Why is using standard templates for the statement of work, RFP, and procurement contract award so important?
Be sure to include an introduction and conclusion as well. Be sure to also include your references (in APA format).
|
Determine the specific impulse of this engine
: Determine the specific impulse of this engine when the compressor pressure ratio is 9 and the temperature at the turbine inlet is 700°F.
|
|
Describe the differences between the two types of documents
: Describe the differences between the two types of documents; - discuss when you would use one or the other;
|
|
Why the pressure ratio for maximum efficiency is less
: For the same maximumto-minimum temperature ratios, explain why the pressure ratio for maximum efficiency is less than the pressure ratio for maximum work.
|
|
Discuss ethical practices utilized by law enforcement
: Identify, define, examine, and discuss the crimes potentially committed by Juan and Jamal.- Identify the victim(s) in this scenario.
|
|
Research and present two templates for request for proposal
: Research and present at least 2 templates for request for proposal (RFP) that most closely align with your Key Assignment project.
|
|
How do you personally relate to the music
: What, specifically about the sound, lights, and imagery you experienced creates the most affect or is the most memorable to you?
|
|
Explain bid process to include preparing rfp requirements
: Explain the bid and proposal process to include preparing RFP requirements, preparing a proposal, responding to and evaluating bids, and contract formation.
|
|
What processes will the team focus on
: What processes will the team focus on? Which processes should not be included and why and what are the boundaries of the process I should improve? What is the start point and stop point of the process?
|
|
Find the back work ratio and the network output
: A gas-turbine plant operates on the regenerative Brayton cycle with two stages of reheating and two-stages of intercooling between the pressure limits of 100 and 1200 kPa.
|