Reference no: EM131149773

Lab: Setting up the Arduino

Introduction:

I will be getting acquainted with the Arduino board in this lab. I will familiarize myself with the parts and get a basic understanding of the IDE program that will operate the different functions. After that in the second section I will be modifying the basic program and measuring the duty cycle on the board itself.

Equipment/Components:

· Arduino Uno
· USB Cable

Procedure:

1. Lab 1a: Procedure:

· Watch the video: Tutorial 01 for Arduino: Getting Acquainted with the Arduino (https://youtu.be/fCxzA9_kg6s)
· Download and install the Arduino IDE.
· Create a new Sketch and give it the name Lab1a_Blink_G000xxxxxx where you have included your Grantham ID into the file name.
· Type in the code provided in Chapter 1 for the Blink program and upload to the Arduino. Note that if the program is working correctly that the onboard LED will blink indefinitely.
· Capture a screenshot of your completed sketch.

2. Lab 1b:Procedure:

· Adjust the Blink program such that the onboard LED stays on at all times.
· Connect a jumper wire to pin 13 of the Arduino and another jumper wire to the Ground pin.
· Upload your new program to the Arduino.
· With a Digital Multimeter, measure the exact voltage between pin 13 and ground.
· Take a picture of the Arduino board in run mode and include the voltage display of the DMM.
· Redesign your program to meet the following specifications:
· Over a 10 second period of time the onboard LED and pin 13 must exhibit a duty cycle of 40%
· Save the redesigned sketch with the filename Lab1b_DutyCycle_ G000xxxxxx where you have included your Grantham ID into the file name.
· Include a screenshot of your redesigned code and pictures of measurements of the DMM display to confirm the voltages during each portion of the cycle.