Procedure described in the dioxouranium experiment

Assignment Help Chemistry
Reference no: EM13184916

The dioxouranium(vi) cation (urany1,uo2)can be seperated and identified using the procedure described in the experiment. the spot test results for this cation with the with the following test reagents are k4fe(cn)6 red-brown

kscn no reaction,dmg/nh3 pale yellow

a: based on these data what would be the best test reagent for uo2

b:the R1 value of uo2 in the solvent system used in this module is 0.68. explain which of the other cation tests used in this expirment it would interfere with,what alternate tesr reaget you would therefore use to identify that other cation and which of the two tests should be performed first

Reference no: EM13184916

Questions Cloud

Give reasons for high and low production cost reservoirs : Show that if oil is produced from two reservoirs, one with high marginal cost and one with low marginal cost, it is not possible for the Hotelling rule to be satisfied for each reservoir simultaneously. Give two reasons that oil might be produced ..
State solvent travel only half way up the chromatographic : the solvent travel only half way up the chromatographic paper in the spot testing chromatogram.predict the effect of this procedural change on the solution of the cation in the standard mixture
Find average power per square meter of wind farms to rise : Assume that current wind farms produce 2.5 W/m2. Succinctly explain whether you would expect the average power per square meter of wind farms to rise or fall as the production of wind energy expands to, say, 10% of our primary energy consumption...
State reaches the top of the chromatographic : Once the solvent front reaches the top of the chromatographic paper,solvent begins to evaporate from the top edge of the paper, and the remaining solvent continues to move up the paper.
Procedure described in the dioxouranium experiment : The dioxouranium(vi) cation (urany1,uo2)can be seperated and identified using the procedure described in the experiment. the spot test results for this cation with the with the following test reagents are k4fe(cn)6 red-brown
Determine the economic service life and corresponding aw : A new gear grinding machine for composite materials has a first cost of P=$100,000 and can be used for a maximum of 3 years. Its salvage value is estimated by the relation S=P(0.85)n, where n is the number of years after purchase. The operating cost ..
What is the predicted price of an ocean view unit : A researcher has developed the following regression equation to predict the prices of luxurious Oceanside condominium units, Picture , where Price = the price of a unit (in $thousands), Size = the square footage (in square feet), View = a dummy varia..
Compute the change of volume of the cube : Calculate the change of volume of the cube at a depth of 1.000 km (disregarding the effects of temperature). Take the mean density of sea water as 1.03 g/cm3.
State the capillary and start again or prepare a fresh : sample melts before you were ready to read the temperature. Should you cool the capillary and start again or prepare a fresh sample? Explain.

Reviews

Write a Review

Chemistry Questions & Answers

  Calculate the molar enthalpy of neutralization

The heat effect of the neutralization reaction NaOH(aq) + HCl(aq) is measured in an open adiabatic solution calorimeter (not a coffee cup calorimeter) The heat capacity of the calorimeter itself is 456 J/K.

  What is the concentration of the resulting solution

if .025 grams of Pb(NO3)2 is dissolved in 100. grams of H2O, what is the concentration of the resulting solution in parts per million?

  What mass of carbon dioxide is produced

What mass of carbon dioxide is produced from the complete combustion of 7.50×10^-3g of methane?

  What volume of gas will be collected for complete reaction

If O2 is collected over water at 40.0 Celsius and a total pressure of 737 mmHg, what volume of gas will be collected for the complete reaction of 23.92 g of NiO?

  How much energy is released by the combustion

ow many grams and how many moles of octane must be burned to release 450 kcal?

  State ammonia nh3 to prepare a buffer solution

How many grams of dry NH4Cl needed to be added to 1.50L of a 2.00M solution of ammonia NH3 to prepare a buffer solution that has a pH of 8.60?

  How many moles of o2 are required to react

In 2C4H10+13O2->8CO2+10H20 how many moles of O2 are required to react completely with 4.4 Moles of C4H20?

  Explain which has been accelerated to a kinetic energy

What is the velocity (m/s) of a doubly protonated ion with a m/z ration of 324.9, which has been accelerated to a kinetic energy of 0.75 MeV?

  What is the final temperature

a block of aluminum with the volume of 96.5 g absorbs 65.3 J of heat. If the initial temperature is 31.2 degrees celcius, what is the final temperature.

  What is the volume of the balloon

A balloon containing 34.5 L of a gas at room temperature (25.0 oC) is heated to 73.5 oC. What is the volume of the balloon at this new temperature?

  Calculate the concentration of magnesious, calcium

a corrosion technologist pipetted a 100 ml hard water sample and titrated it with 37.64 ml of 0.01 M EDTA solution for a total endpoint, and 29.32 ml of 0.01 M EDTA solution for a calcium endpoint.

  Compute the ph if the resulting solution

consider the following mixtures. in each case either calculate the pH if the resulting solution is a buffer solution or state why the solution does

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd