Prepare a metes-and-bounds description for the parcel

Assignment Help Civil Engineering
Reference no: EM131147069

Draw a plat map of the parcel in Problem 21.24 at a convenient scale. Label all monuments and the lengths and directions of each boundary line on the drawing. Include a title, scale, north arrow, and legend.

Problem 21.24:

Prepare a metes-and-bounds description for the parcel shown in the accompanying figure. Assume all corners are marked with 1-in.-diameter steel rods, and a 20-ft meander line setback from Indian Lake.

2026_9c3b07e5-3542-4b89-a440-fcef7593fd58.png

Reference no: EM131147069

Questions Cloud

Identify a quantifiable measure for the company : Identify a quantifiable measure for the company such as service time, percent of errors, etc. Select one of the following quality control tools to evaluate this data:
Create a gantt chart : Create a Gantt chart that displays 36 months, using the Office Timeline tool or any other tool to produce a Gantt chart.
What are the cons of using such a system : What are "good time" credits? How do the use of good time credits and "voluntary" prison programs aimed at rehabilitation help the corrections system to reduce the length of time an offender serves? What are the other benefits of this practice for..
Briefly explain choice theory and routine activities theory : Briefly explain choice theory and routine activities theory and the relevance to digital crime
Prepare a metes-and-bounds description for the parcel : Prepare a metes-and-bounds description for the parcel shown in the accompanying figure. Assume all corners are marked with 1-in.-diameter steel rods, and a 20-ft meander line setback from Indian Lake.
Which case held that lie detector result were not admissible : Which case held that that lie detector results were not admissible in criminal cases
Explain the major short run and long cost functions : Analyze the major short run and long cost functions for the low-calorie, frozen microwaveable food company given the cost functions below.
Find the dividend yield and capital gains yield : What if Timco's dividends grow at 6% per year forever?- What if Timco's dividends grow at 6% for one year, than at 10% forever after that?
What types of unemployment may exist : When the economy is at full employment, what types of unemployment may exist? Over the last 100 years, the U.S. labor productivity growth rate experienced its largest declines.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the maximum elevation of any high point

An uncontrolled mosaic is required for an environment project using 1/30000 photos. only the central area of each photo is used for the mosaic

  Determine deviation at the top of trajectory caused by wind

A fireworks shell is launched vertically from point A with speed sufficient to reach a maximum altitude of 500ft. A steady horizontal wind causes a constant horizontal acceleration of 0.5ft/sec^2, but does not affect the vertical motion.

  Find the magnitude and phase of all three line to line

In a three phase balanced system, a delta connected source supplies power to a wye connected load. If the line impedance is 0.2 + j0.4 ohms, the load impedance 3 + j2 ohms, and the source phase voltage

  Type of cement

What type of cement would you use in each of the following cases? Why?

  Determine max hoop stresses on inside fibers of rifle barrel

Determine the maximum hoop stresses on the inside fibers of a rifle barrel which is 3 feet long with an O.D. = 3.0" and an I.D. = 1.0". The internal pressure = 10,000 psi. Use the F.E. reference manual for determining these stresses.

  Determine the pressure variation in the flow field

A plane flow field is developed by addition of a free vortex and a uniform stream in the positive x direction. If the vortex is located a distance a from the origin, find the pressure variation in the flow field.

  How far upstream is depth within 100mm of uniform depth

A dam located in a channel of rectangular cross-section which carries water flowing at a rate of 8.75m3/s. The depth of water upstream of the dam is 2.5m. the channel is 5m wide,

  What is the maximum positive coordinate reached by particle

The position of a particle moving along an x axis is given by x = 17t2 - 5.0t3, where x is in meters and t is in seconds. (a) Determine the position, velocity, and acceleration of the particle at t = 3.0 s. x = m v = m/s a = m/s2

  Determine the force each pin exerts on the plate

determine the force each pin exerts on the plate

  What is the waters temperature at the exit of the turbine

A turbine operates at steady state with steam flowing through it at a rate of 36 kg/min. The steam enters the turbine at a temperature of 600C and a pressure of 8 MPa and exits at a pressure 90% lower with a quality of 70%.

  What volume of cmfr would be required to remove

The CMFT has a 4000 gallon volume. What wastewater flowrate can be treated in this CMFR in order to remove 98% of the BOD5

  Calculate the total active earth force per foot of wall

Calculate the total active earth force per foot of wall and its point of application from the base of the wall. Use Rankine theory. Calculate the total active earth force per foot of wall if the angle of wall friction between backfill and wall is 2..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd