### Performing fatigue threshold test using manual load control

Assignment Help Civil Engineering
##### Reference no: EM131069787

Performing a fatigue threshold test using manual load controls in a servo hydraulic testing machine can be an extremely time-consuming task. Calculate the minimum number of days required to determine the threshold stress intensity factor range, ?K0, of a material at a cyclic frequency of 1 Hz, if ?K0 is defined as the threshold corresponding to a growth rate of no more than 10-11 m/cycle and if the resolution of the crack detection technique is 0.05 mm.

### Write a Review

#### Determine the reaction components at a and the tension

The hinge at A and the cable that attaches at points B and C support rigid bar ABC. Determine the reaction components at A and the tension in the cable.

#### Determine the 50-kg crates velocity when t is given

If the force exerted on cable AB by the motor is F =(100^3/2) N, where t is in seconds, determine the 50-kg crates velocity when t = 5s. The coefficents of static and kinetic friction between the crate and the ground are u(s) =.4

#### What is the future worth of per year of each plan at age 85

Mike and Susan hope to retire a few years early, they decided to pay closer attention to the predicted amount of retirement benefits and do some analyses on the numbers.

#### Calculate the true volumetric flow rate of methane in the

A previously calibrated rotometer is being used to measure a gas flow. The old calibration curve is a straight line described by the following equation:

#### Calculate cc and use the aisc equations e2-1 and e2-2

If design is needed, use a W-built-up cross section; select the W section and the thickness of the plate. Calculate Cc and use the AISC equations E2-1 and E2-2 to determine the allowable stress for each axis and ultimately the allowable load for t..

#### What uniform annual series of cash flows over 12-year period

What uniform annual series of cash flows over a 12-year period is equivalent to an investment of \$5,000 at t= 0, followed by receipts of \$600 per year for 11 years and a final receipt of \$1,600 at t= 12 of the investor's time value of money is 6% ..

#### Estimate the bending moment at the base of the chimney

A cylindrical chimney,1 m in diameter and 2.5 m tall is exosed to a uniform 50km/hr wind at standard atmospheric conditions.End effects and gusts may be neglected.

#### What will be the effect of making an indentation very close

When making hardness measurements, what will be the effect of making an indentation very close to a preexisting indentation. Why.

#### Compute the radius of the second curve

Two converging tangents have azimuths of 300 deg and 270 deg respectively, while thAt of the common tangent is 320 deg. The distance from the point of intersection of the tangents to the PI of the second curve is 100m while the stationing of the PI o..

#### Determine the velocity at which he lands on the ground

Due to atmosphere drag, the deceleration equation is 60a=588.6-30v^2 in m/s^2. Find the velocity at which he lands on the ground. This velocity is referred to as terminal velocity, which is found by letting the distance of the fall (y) go to infin..

#### What would be the absolute pressure of carbon dioxiode

What would be the absolute pressure, P in kPa, of carbon dioxiode at 20 degrees celcious if the specific weight of carbon dioxide at 20 degrees celcious is 18 N/m^3 and the gas constant, R =1.889x10^2 J/kg*K.

#### Determine the internal shear force and moment in the jib

The jib crane supports a load of 750 lb from the trolley which rides on the top of the jib. The members of the crane are pinned together at B, E, and F and supported by a short link BH.