Methane gas will be produced in anaerobic decomposition

Assignment Help Chemistry
Reference no: EM13174001

A formula C6H8ON2S3P can be used to describe chemical make-up of MSW. How much of methane gas will be produced in anaerobic decomposition assuming a complete conversion of MSW into CH4CO2NO, and SO2.

a 1 mole methane

b. 2 moles methane

c. 3 moles methane

d.8 moles methane

d. none of the above

Reference no: EM13174001

Questions Cloud

What mass of procaine hydrochloride is injected : the anesthetic procaine hydrochloride is often used to deaden pain during dental surgery. the compound is packaged as a 10.% solution (by mass; d= 1.0 g/mL) in water. IF your dentist injects 0.50 mL of the solution, what mass of procaine hydrochlo..
Considered unsaturated and saturated or supersaturated : Would a solution that has a molarity of 0.990 M KNO3 and a density of 0.988 g/mL be considered unsaturated, saturated, or supersaturated?
State treatment of the solution with cio : A solution may contain any of the Group III cations. Treatment of the solutio with CIO- in alkaline medium yields a yellow solution and a colored precipitate.
What annual rate of return must the endowment fund earn? : A permanent endowment at the University of Alabama is to award scholarships to engineering students. The awards are to be made beginning 5 years after the $10 million lump-sum donation is made
Methane gas will be produced in anaerobic decomposition : How much of methane gas will be produced in anaerobic decomposition assuming a complete conversion of MSW into CH4CO2NO, and SO2.
State and assume a negligble volume change : moles of H30+ or OH- must you add to 8.92 L of HA solution to adjust its pH from 4.34 to 5.09? assume a negligble volume change
Plot the process path in a p-v diagram : Helium gas is heated at constant volume from a state of 100 kPa, 300 K to 500 K. A following process expands the gas at constant pressure to four times the initial volume.
Concentration of titanium in the original unknown solution : As a reference, a standard mixture containing 2.26 micrograms Co/mL and 1.92 micrograms Ti/mL was prepared and measured to have a signal-to-signal ratio of 2.41 Ti: 1.00 Co.
Determine the m&o costs for alternative s : Alternative S has a first cost of $175,000 and a $40,000 salvage value after 5 years, but its annual M&O costs are not known.

Reviews

Write a Review

Chemistry Questions & Answers

  What is the final volume of the balloon

A balloon is filled to a volume of 7.00 x 102 mL at a temperature of 20.0 oC. The balloon is then cooled at constant pressure to a temperature of 1.00 x 102 K.

  What will be the volume

A sample of neon has a volume of 270 mL when it is at a pressure of 831 mmHg. What will be the volume when the pressure is increased to 1238 mmHg?

  How much solid sodium sulfate should you add

You need to make an aqueous solution of 0.180 M sodium sulfate for an experiment in lab, using a 250 mL volumetric flask. How much solid sodium sulfate should you add ?

  Which of following alkenes can exhibit cis-trans isomerism

Which of the following alkenes can exhibit cis-trans isomerism?

  Which of the following compounds you expect to be ionic

Which of the following compounds would you expect to be ionic?

  How many joules of energy are need

The specific heat of silver is .24 j/g. How many joules of energy are need to warm 4.37g from 25 to 27.5 ?

  Determine the mass of carbon dioxide produced

Determine the mass of carbon dioxide produced when .85 grams of butane reacts with oxygen according to the following equation : 2C4 H10 + 13O2 ->8CO2 + 10H2O

  How much electrical power can be generated

Wind provides a source of renewable energy that is increasingly being tapped. Modern wind tubines can conbert up to 30% of the kinetic energy of the incoming wind blowing through their blades to electicity.

  State the decomposition of no2

The decomposition of NO2 (shown below) has a KP = 4.8 × 10-6 at a certain temperature. If 1.36 atm of NO2 is placed in a flask at this temperature

  How many distinct terminal alkynes exist with molecular form

The product formed by the reaction of 3-methyl-1-butene with mercuric sulfate and sulfuric acid is?

  Explain what is the limiting reactant

What is the limiting reactant? b) How many grams of magnesium hydroxide can be theoretically obtained? c) If only 2.009g of magnesium hydroxide are obtained, what is the percent yield of the reaction?

  Draw lewis dot structure for both

Consider the chemical species IF5 and IF4+

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd