#### All Pages

Assignment Help Civil Engineering
##### Reference no: EM131069690

The surfaces of metallic materials are usually shot-peened for the purpose of suppressing crack formation due to contact fatigue.

(a) Suggest at least three methods for enhancing the contact fatigue resistance of ceramic surfaces.

### Write a Review

#### What is the volume of the lake in cubic feet

A shallow lake can be considered a CFSTR. Nitrification, the conversion of ammonia to nitrate (NH3 -> NO3-) occurs in the lake according to first – order kinetics. One stream feeds the lake and one stream empties the lake with the flow rate in both b..

#### Which the original 13 colonies were surveyed

Fixed GPS broadcast stations enable users to make differential measurements to other points whose positions are needed. In the US, there are two such networks two such networks of broadcast stations, name one (blank)

#### Recommend two different solutions that could allow the sites

Your next project site is an old landfill, which reaches a depth of 30 feet. Below, there are many layers of both competent and caving soils, but none of the competent soil layers capable of giving the needed bearing capacity under the 12’’ diameter ..

#### Determine the value of u corresponding to equilibrium

The constant of spring AB is k, and the spring is un stretched when θ = 0. Knowing that R = 10 in., a = 20 in., and k = 5 lb/in.,

#### What is the volume of required soil excavated in borrow pit

Soil is excavated from a borrow to construct an embankment with a net volume of 50,000 cy. This is performed by compacting 12-in layers of the soil to a dry weight of 110 pcf at a moisture content of 18%.

#### What are the adjusted elevations for benchmarks b-c and d

differential leveling between benchmarks A,B,C,D, and A gives elevation differences(m) of -15.632, 32.458, 38.214, and -55.025, and distances(km) of 4,6,5, and 3 respectively.

#### Determine the asd reference and adjusted design values

Determine the ASD reference and adjusted design values for the following members and loading conditions. All members are Select Structural Southern Pine and are fully braced to prevent lateral torsional buckling.

#### How far apart must two 18 m diameter tanks be placed

How far apart must two 18 m diameter tanks be placed such that their stress overlap is not greater than 10% of the contact stress at depths of 10, 20, and 30 m

#### Determine what is the average stream flow in the period

A catchment has an area of 150 ha and a runo /rainfall ratio of 0.40. If due to a 10 cm rainfall over the catchment a stream flow at the catchment outlet lasts for 10 hr, what is the average stream flow in the period

#### Determine the critical depth with a bottom width

a channel which has a trapezoidal cross-section with a bottom width of 6 m and side slopes 1:2 discharges water at a rate of 5 m3/s. Determine the critical depth.

#### Find when is the rider going to reach the stopping point

If we apply a breaking system to a skateboard while the speed of the skateboard is 5Milies per hour, the rider average weights is 180bounds while his height is 170 cm. You can assume the distance as it is 50meters.

#### Find what is the op amp output voltage with a digital input

The reference current for the DAC0808 is 2.0 mA. With the DAC output connected to the inverting input of an op amp with a feedback resistor of 5.0 kohms, what is the op amp output voltage with a digital input of 0x80