### How the firm should adjust its mix of capital and labor

Assignment Help Civil Engineering
##### Reference no: EM131034564

Suppose a firm finds that the marginal product of capital is 60 and the marginal product of labor is 20. If the price of capital is \$6 and the price of labor is \$2.50, describe how the firm should adjust its mix of capital and labor

### Write a Review

#### Find the angle in degrees between vector a and the resultant

The acceleration of a particle traveling along a straight line is a=(1/4)s^1/2 m/s^2, where s is in meters. If v=0, s=1 m when t=0, determine the particle's velocity at s=2m

#### Parabolic trajectory of the falling prey

A hawk flying at 2 m/s at an altitude of 45 m accidentally drops its prey. The parabolic trajectory of the falling prey is described by the equation below until it hits the ground, where y is its height above the ground and x is its horizontal dis..

#### Find the change in thickness of the clay that will occur if

A 10 ft layer of normally consolidated saturated clay is found at depth of 20 ft beneath a formation of partially saturated sandy silt with unit weight of 115 lb/ft cubed. Void ratio of the clay is 1.5 and specific gravity is 2.6.

#### Calculate the angles made by f with the positive x

A force is specified by the vector F= 120i-160j+80k lb. Calculate the angles made by F with the positive x-,y-, and z- axes.

#### Find the speed of the blocks after block

Block one has a mass of 1.5kg. Block two has a mass of 3.0kg. Treatthe pulleys as hoops. The radius of pulley one is 8.70m. The massof pulley one is 4.5kg.

#### Determine the new q through the system at c

Parallel pipes, fixed overall H, ?EGL or hl = 75'. Elevated Tank A water surface is at El 625, 3000' away is Tank B with free surface El 550 They are connected by a 12" dia cast iron pipe.

#### How many helium balloons can be filled in the tank

a 150 L helium tank contains pure helium at a pressue of 1825 psig. How many 3.5L helium balloons can be filled from the helium in the tank? (Assume an atmospheric pressue (14.7 psia) and a temp of 298K.

#### Determine the coefficient of kinetic friction

THE 2.5 MG VAN IS TRAVELLING WITH A SPEED OF 100KM/H WHEN THE BRAKES ARE APPLIED AND ALL 4 WHEELS LOCK. IF THE SPEED DECREASES TO 40KM/H IN 5S.

#### Determine the rate of heat transfer to the rods in the oven

If the rods enter the oven at 30°C and leave at a mean temperature of 700°C, determine the rate of heat transfer to the rods in the oven.

#### Determine the speed before the plunger strikes the stop

If the arm is pulled back such that s= 100 mm and released, determine the speed of the 0.41-kg pinball B just before the plunger strikes the stop, i.e., s= 0. Assume all surfaces of contact to be smooth.

#### Determine the moment of inertia and the radius of gyration

Determine the moment of inertia and the radius of gyration of the shaded area with respect to the x axis.

#### Estimate shaft elongation in millimeters with applied force

A 4.00-cm-diameter, 0.80-m long rod of aluminum 7075-T6 is subjected to an axial tensile force with a factor of safety of 1.75. The yield stress and modulus of elasticity of aluminum 7075-T6 are 500. MPa and 210. GPa, respectively.

#### Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!