How much power can then be cogenerated by the turbine

Assignment Help Civil Engineering
Reference no: EM131250039

A boiler delivers steam at 10 MPa, 550?C to a two stage turbine, as shown in Fig. 9.19. After the first stage, 25% of the steam is extracted at 1.4 MPa for a process application and returned at 1 MPa, 90?C to the feed water line. The remainder of the steam continues through the low-pressure turbine stage, which exhausts to the condenser at 10 kPa. One pump brings the feed water to 1 MPa and a second pump brings it to 10 MPa. Assume all components are ideal. If the process application requires 5 MW of power, how much power can then be cogenerated by the turbine?

1476_f879de6a-5e09-40bb-af58-5f8905fc7de5.png

Reference no: EM131250039

Questions Cloud

What are the business information system requirements : Explain which of the potential approaches to system development (computer-aided software engineering (CASE) tools, joint application design (JAD), rapid application development (RAD), participatory design (PD), or the use of Agile Methodologies sh..
Find the plant efficiency and the efficiency of a carnot : The power plant in Problem 9.16 has too low a quality in the low-pressure turbine section, so the plant wants to apply reheat at 800 kPa. What should the superheat for the reheat be so that the turbine quality stays above 92%?
Ethics and business conduct : Morgan Stanley: Code of Ethics and Business Conduct," and "Starbucks Code of Behavior" discuss the approaches and provisions these two companies have utilized in their attempts to establish credible ethical environments, and the "Strategic Leaders..
Strategy to mitigate the risks in question : What the key risks to a health care organization that fails to allocate sufficient support and resources to a newly implemented health care information system. Propose one (1) strategy to mitigate the risks in question. Provide a rationale to supp..
How much power can then be cogenerated by the turbine : One pump brings the feed water to 1 MPa and a second pump brings it to 10 MPa. Assume all components are ideal. If the process application requires 5 MW of power, how much power can then be cogenerated by the turbine?
Conditions on c guarantee existence of a separating pbe : What conditions on c guarantee the existence of a separating PBE?- For what values of c is there a pooling equilibrium in which both strong and weak Wesleys get out of bed?
Biological fragments of julian prince : Pick two of the faux wiki links in The Biological Fragments of Julian Prince(link above) and write at least a 250 word definition for each in Wikipedia page style. Choose from the following "links": Post-Impact Novels
What is the value of the common stock : Header Motor inc paid a 3.45 dividend last year. At a constant growth rate of 4 percent what is the value of the common stock if the investors require a 10 percent rate of return?
Find the temperature after pump 1 : Assume all components are ideal and find the temperature after pump 1, the total turbine output, and the total process heat transfer.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the error in the horizontal pointing

A total station with a 20"/ div. level bubble is one division out of level on a point with an altitude angle of 38°15'44". What is the error in the horizontal pointing?

  How reliable do you think this estimate is

It the mean annual runoff of a drainage basin of 10000 km^2 is 140 m^3/s, and the average annual precipitation is 105 cm, estimate the ET losses for the area in 1 year. What are your assumptions? How reliable do you think this estimate is?

  Determine the irr of building the corrosion-resistant tower

HZ Wireless must rebuild a cell tower recently destroyed by a tornado. A tower made of normal steel (NS) will cost $30,000 to construct and should last 15 years. Maintenance will cost $1000 per year.

  What diameter is required if the concrete pipe is to carry

A ciricular sewer is laid on a slope of 0.5%. What diameter is required if the concrete pipe is to carry 25 cfs If the desired design mean suction velocity is between 3 and 7 ft/s, is the design acceptable

  Determine the depth of a french drain saturated depth

Determine the depth of a French drain (saturated depth) if the width is 3.0 feet, the effective permeability of the aggregate is 2000 ft/day, and the rate of discharge for 100 feet of trench is 1000 feet^3/day. The trench slope along the flow line is..

  Determine the magnitudes of accelerations of points a and b

The center 0 of the wheel is mounted on the sliding block, which has an acceleration of a0= 8 m/s2 to the right. At the instant when theta=45 degrees, theta dot is = 3 rad/s and theta double dot is = -8 rad/s2.

  What will the wires resistance be if it is stretched to

A wire has a resistance of 1.2×10-2 . What will the wire's resistance be if it is stretched to twice its original length without changing the volume of the wire?

  Determine the strains in each of the transveral axes

A 12inx1inx3in ASTM 36 steel bar is loaded with an axial load of 90,000lbs and a transversal load of 288,000lbs (force applied perpendicular to the 1in side) The proportionality limit is 34,000psi.

  What will be the grade elevation at station

The grade elevation at station 25+00 is to be 946.52 ft. What will be the grade elevation at station 34+86.20 if the grade linerises at the rate of 1.785% between these two points?

  What is the heat transfer for the process

How does pressure vary with volume, and what is the heat transfer for the process?

  Determine the power that must be supplied to the pump at

Crude oil flows through a level section of the Alaskan pipeline at a rate of 1.6 million barrels per day (1 barrels=42 US gallons) the pipe inside diameter is 48 inch and its roughness is equivalent to galvanized iron.

  Find an expression for the flowrate and average velocity

The flow is designed using a rectangular coordinate system whose orgin is at the free surface midway between the walls. The x axis is normal to the walls, and the y axis points vertically downward.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd