Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
using a prism and prism pole in conjunction with a total station, the bottom of the prism pole is placed on point A. the distance from the bottom of the prism pole to the center of the prism (HR) is 4.97 feet. of the prism pole is held at an angle of 2 degrees from vertical, how much horizontal distance is there from the prism to point a?
A cylindrical tank with inside diameter of 300mm and wall thickness of 5mm is subjected to an internal pressure of 2Mpa. The tensile stress in mpa in the wall of the tank is mostly near
A biological reactor is used to treat wastewater from a small community (Q = 100,000 gpd). The influent BOD5 concentration to the reactor is 200 mg/L and the required effluent BOD5 concentration is 30 mg/L.
Determine the maximum hoop stresses on the inside fibers of a rifle barrel which is 3 feet long with an O.D. = 3.0" and an I.D. = 1.0". The internal pressure = 10,000 psi. Use the F.E. reference manual for determining these stresses.
what is the probability that less than 0.5 inches of precipitation will occur in any January? What is the probability that more than 2.5 inches wil
Civil and Environmental Engineering Question, 1. How is the problem of technology choice related to process selection and product design?
The cart takes 5.00s to go from point A to point C, and the cart takes 1.90s to go from point B to point C. What is the cart's speed at point B. Express answer numerically to three significant figures in feet per second.
A reservoir at elevation 700 ft will supply a second reservoir at elevation 460 ft. The reservoirs are connected by 1300 ft of 24-in cast-iron pipe and 2000 ft of 20-in cast iron pipe in series. What will be the discharge delivered from the upper ..
Knowing that each member has a 2 3 4-in. rectangular cross section and that each pin has a 12 -in. diameter, determine the maximum value of the average normal stress (a) in member BE, (b) in member CF.
However, design codes which deal with shear friction design place an upper limit on the magnitude of the shear force for which the plane can be designed. Explain why this is so.
A concrete mix with a 3-inch slump, w/c ratio of 0.50, and sand with a fine- ness modulus of 2.4 contains 1700 lb/yd3 of coarse aggregate. Compute the required weight of coarse aggregate per cubic yard.
Steam enters an adiabatic turbine steadily at 3 MPa and 300 *C and leaves at 70 Kpa and 100 *C. If the power output of the turbine is 2 MW, determine a) the isentropic efficiency of the turbine and b) the mass flow rate of the steam flowing throug..
The motion of a particle on the surface of a right circular cylinder is defined by the relations, R = A, theta = 2pi(t), and z=Bsin(2pi)(nt), where A is a constant. Determine the magnitudes of the velocity and acceleration of the particle at any t..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd