How long will take for consolidation to occur in the field

Assignment Help Civil Engineering
Reference no: EM13317765

For a proposed level of stress, ninety percent of consolidation occurred in 15.8 minutes (t90=15.8min) for a laboratory consolidation test of a 12.7 mm thick clay specimen. In the field a 6.5m layer of the clay is sandwiched between sand layers. How long will it take for 50% and 90% consolidation to occur in the field deposit of clay? How long will it take if the field clay layer is bounded on the bottom by an impervious material?

Reference no: EM13317765

Questions Cloud

Compare the settlement from laboratory consolidation test : If an embankment is placed that adds an average additional stress of 32psi to the clay, compare the settlement from the laboratory consolidation test to the settlement from the estimated field consolidation curve.
What does the cost of a good or service reflect : What does the cost of a good or service reflect? Will producer continue to supply a good or service if consumers are unwilling to pay a price sufficient to cover the cost?
What is the amplitude of the oscillating electric field : The maximum allowed leakage of microwave radiation from a microwave oven is 5.0 mW/cm^2, what is the amplitude of the oscillating electric field
What is being held constant when the supply curve : What is being held constant when the supply curve is constructed for a specific good like pizza of automobiles? Explain why the supply curve for a good slopes upward to the right.
How long will take for consolidation to occur in the field : For a proposed level of stress, ninety percent of consolidation occurred in 15.8 minutes (t90=15.8min) for a laboratory consolidation test of a 12.7 mm thick clay specimen. In the field a 6.5m layer of the clay is sandwiched between sand layers.
Two centuries ago there were more buffalo than cattle : Two centuries ago there were more buffalo than cattle in the United States. Even though millions of cattle are killed for beef consumption each year, the cattle population continues to grow while the buffalo are virtually extinct. Why?
Calculate at what angle is the airplane banked : A jet airplane is in level flight. The mass of the airplane is m = 8830 kg. calculate At what angle is the airplane banked
How to determine the rating curve of the spillway : Consider a 75-ft wide overflow spillway with no piers and a design head of 18 ft. The crest elevation of the spillway is 2400 ft and the streambed elevation just upstream of the spillway is 2350 ft.
Compute the tension in the wire : A 0.80 kg framed picture hangs by a light wire on a nail. The 50 cm long wire is attached to both ends of the 40 cm wide picture frame, What is the tension in the wire

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the average degree of consolidation for clay layer

A normally consolidated clay layer is 4 m thick (one way drainage). From the application of a given pressure, the total anticipated primary consolidation settlement will be 80mm. What is the average degree of consolidation for the clay layer.

  Determine the velocity and acceleration of point b

The velocity of the center point of the wheel is constant at 20 ft/sec to the right. For the instant, determine the following: a) The velocity and acceleration of point B (which is attached to the wheel) measured with respect to ground.

  Determine what is the instrumental and statistical error

During an experiment, the depth of a water flow in a flume is measured five times by using a ruler with 1/16-in division. The results from these measurements are 4.88 in, 5.06 in, 5.03 in, 5.13 in, 4.94 in. What is the instrumental error and what ..

  What portion of the 263rd payment goes towards reducing

Consider a $50000, 30 years loan at 12% APR with monthly uniform payments. What portion of the 263rd payment goes towards reducing the principal and what portion is interest

  Determine critical depth in circular pipe of inches diameter

determine critical depth in a circular pipe of 36 inches diameter and roughness coefficient of 0.015. The flow rate is 15 cfs. So = 0.002

  Determine the outlet temperature of the engines compressor

The thermal efficiency of an aircraft gas turbine engine (turbojet, based on ideal Brayton cycle) is 25%. The aircraft travels at a speed 770 km/h at an altitude 6800 m above sea level (standard atmospheric air). The combustion chamber outlet temp..

  Find the support movements draw sfd and bmd

A fixed beam of span 6m carries point loads 20kN and 15kN at 2 m and 4 m from the left end respectively. Find the support movements draw SFD and BMD

  What is the dry unit weight and the saturated unit weight

What is the dry unit weight, the saturated unit weight, and the buoyant unit weight, of a soil having a void ratio of 0.5 and a value of Gs of 2.7

  Develop a spreadsheet application that will display in table

develop a spreadsheet application that will display in a table the values of modulus of elasticity Ec for concrete having unit weight ranging from 95 pcf to 155 pcf (in steps of 5 pcf) and compressive strength ranging from 3500 to 7000 psi

  Calculate the isentropic efficiency of the turbine

At steady state air enters a turbine at a pressure of 0.4 MPa and a temperature of 77C. As a result the turbine generates 80 kJ of work per kg of air flowing. The air exits the turbine at a pressure of 1 bar.

  Draw the shear diagram for the shaft

Draw the shear diagram for the shaft. The bearings at and exert only vertical reactions on the shaft

  What are slack variable in linear programming constraint eqn

what is a dummy activity and slack activity and also what are slack variables in linear programming constraints equation

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd