How fast is the river flowing

Reference no: EM13713494

Question: A boat takes 3.20 hours to travel 30.0 km down a river, then 6.80hours to return.

Question 1: How fast is the river flowing?

I will only give best answer if all the steps are shown and correct. Thank you!

Reference no: EM13713494

Questions Cloud

Find the maximum velocity in the tube : Water at 27 C flows through a tube of diameter d = 50 mm. If the flow is fully-developed and has a mass flow rate of 0.01 kg/s, find the maximum velocity in the tube, and the pressure gradient, dp/dx

Evaluate the thermal efficiency : A quantity of water within a piston-cylinder assembly executes a carnot power cycle. During ISOTHERMAL expansion, the water is heated from saturated liquid at 45 bar until it is a saturated vapor. The vapor then expands adiabatically to a pressure of..

Estimate what is the drag force on a car : What is the drag force on a 1.6 m wide, 1.4 m high car traveling at 11 m/s (25 mph)? Suppose that the density of air is 1.2 kg/m3

Insulated reactor operating at steady state-burns completely : Methane gas (CH4) at 25° C, 1 atm enters an insulated reactor operating at steady state and burns completely with x % of theoretical air entering at 25°C, 1 atm. Calculate the adiabatic flame temperature (AFT) at x=100, 200, 300 and 400 % and plot t..

How fast is the river flowing : A boat takes 3.20 hours to travel 30.0 km down a river, then 6.80hours to return. How fast is the river flowing

What is the view factor when the smaller sphere is displaced : Determine the view factors F12 and F21 for two concentric spheres characterized by radii R1 and R2, where R2 > R1. What is the view factor when the smaller sphere is displaced from the origin by R1/2 and R2 > 4R1?

Explain why the radiation leaving an enclosure : Explain why the radiation leaving an enclosure (e.g. an oven kept at temperature T) through a small hole is a very good approximation for blackbody radiosity at temperature T.

Aluminium rod corresponding to the design safety factor : A solid round aluminium rod (made of 6061-T6) has a mean yield strength Sy = 40.0 ksi with standard deviation of 4.0 ksi, the rod is to be subjected to a mean static axial load of P = 25 kip with a standard deviation of 2.5 kip.

Dimensional analysis to find expression for pump efficiency : The efficiency of a pump is assumed to be a function of the flow rate Q (cubic ft/sec), pressure increase? p, pipe diameter d, and density and viscosity of the fluid. Use dimensional analysis to find an expression for the pump efficiency.

User Account

All Pages