How can you increase the performance of the least efficient

Reference no: EM13555175

There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively. Which reactor is more efficient and why? If all these are CMFR reactors, how can you increase the performance of the least efficient reactor?

Reference no: EM13555175

Questions Cloud

Find the elastic modulus of the material used to construct : Given a type of material used in a wire with diameter (d = 0.25 in) that stretches 2.3 inches while 80 feet of length is under tensile load of 1800 pounds. Find the elastic modulus of the material used to construct the wire.

What air pressure in psig is needed to raise the maximum : Assume the lubricating fluid is changed to oil with a dynamic viscosity of 1.4X10E-3 lbf-s/ft^2. Now what air pressure, in psig, is required to overcome shear force ? Use the same lift rate of 0.1 ft/sec.

What is the probability that there will be at least one hot : Weather records for a certain region indicate that there is a tendency for two hot summers to occur in a row. From the statistics for the region, the following information has been es tahlished

Derive a formula for the steady rate of descent : This problem involves a cylinder falling inside a pipe that is filled with oil. The small space between the cylinder and the pipe is lubricated with an oil film that has viscosity ?

How can you increase the performance of the least efficient : There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively

Determine the magnitude of its acceleration at this instant : Car traveling along a circular curve that has a radius of 50m. if its speed is 16m/s and is increasing uniformly at 8 m/s^2 determine the magnitude of its acceleration at this instant.

Determine the maximum water table elevation : A canal was constructed running parallel to a river 1500 ft away. Both fully penetrate a sand aquifer with a hydraulic conductivity of 1.2 ft/d. The area is subject to rainfall of 1.8 ft/y and evaporation of 1.3 ft/y. The elevation of water above the..

What is the discharge rate per unit width of the aquifer to : To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface. It is thought that no evapo-transpiration would occur below that depth.

What is the alkalinity of this water expressed as mg/l : A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3?

User Account

All Pages