Heat conduction experienced by the person to the ice

Assignment Help Mechanical Engineering
Reference no: EM13701045

A person with a uniform temperature of 29 C is standing barefoot on a block of ice in a breezy room at 20 C with an effective convection coefficient equal to 8 W/m^2 C. The surface area exposed to forced convection is 1.6 m^2. Due to the angle of incidence the area exposed to thermal radiation, which behaves as a gray surface, is one half of the exposed surface area. The absorptive of the person and the temperature of the radiation source are approximately 0.6 and 91C, respectively.

(Note: the Stefan-Boltzmann constant is 5.67x10^-8 W/m^2K^4)

1) Write the Conservation of energy for steady state, substituting the particular relationships for each mode of heat transfer.

2) Determine the heat conduction [W] experienced by the person to the ice, indicating the direction of heat transfer.

3) If water has a heat of fusion of 334 kJ/kg, estimate how much water has accumulated after 2 minutes [in^3].

Reference no: EM13701045

Questions Cloud

What is the gauge pressure and absolute pressure : Atmospheric pressure is101.3 kPa (or else 14.69 psi). You take a vessel, and pressurise it to 350 kPa (or 50.75 psi) above the atmospheric pressure, and connect pressure gauges to the vessel, calculate What is the gauge pressure? What is the absolute..
What value would be displayed on the scada screen : A 4 20 mA signal is sent to a 12-bit Modicon PLC input card, which in turn, sends this to a SCADA. If the signal happens to be 14.25 mA, calculate: What percentage of 0 - 100% will this represent?
Cylinder device nitrogen gas executes a carnot power cycle : In a sealed piston cylinder device Nitrogen gas executes a CARNOT POWER CYCLE. The source and sink temperatures are 999 K and 333 K. Minimum pressure in the cycle is 20 kPa. The minimum volume is (1/40) of the maximum volume in the cycle. The cycle w..
A hollow cylinder made of copper has an outer diameter : A hollow cylinder made of copper has an outer diameter of 200 mm, an inner diameter of 50 mm and a height of 100 mm. Under load P the final height of the cylinder is 60 mm and the inner diameter is 45 mm. If the strength coefficient K is 315 Mpa and ..
Heat conduction experienced by the person to the ice : A person with a uniform temperature of 29 C is standing barefoot on a block of ice in a breezy room at 20 C with an effective convection coefficient equal to 8 W/m^2 C. The surface area exposed to forced convection is 1.6 m^2.
What is the temperature and humidity of the outlet stream : A stream of air at 1 bar, 20 °C, 30% RH, at 100 m3/min is mixed with a stream of hot moist air at 120 °C, 75% RH, at 20 m3/min. What is the temperature and humidity of the outlet stream?
How did cincinnati zoo benefit from business intelligence : How did the Cincinnati Zoo benefit from business intelligence and how did it enhance operational performance and decision making?
A rotor is being designed for a wind turbine : A rotor is being designed for a wind turbine. The rotor will have a diameter of D = 70 m. A single airfoil will be used for the length of the blades. The airfoil has its minimum drag to lift ratio when the lift coefficient is 1.0. Two options are bei..
Size a suitable orifice plate to meter steady flow of water : Size a suitable orifice plate to meter the steady flow of water at 20 °C through 138 cm diameter pipe if the nominal flow rate expected is 200 kg/s and the pressure drop must not exceed 15 cm mercury.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A heat engine operates in a carnot cycle between720degc

a heat engine operates in a carnot cycle between72.0degc and345degc. it absorbs21600j of energy per cycle from the hot

  For the diffuser shown in the attached image find the mass

a diffuser is a device that the flow of air in order to recover a pressure loss. for the diffuser shown in the attached

  Explain workout velocity and range of shell fired

Workout velocity and range of shell fired, Why is it possible to consider the vertical and horizontal motion of a projectile independently of each other.

  Experiment can be used to investigate heat transfer

experiment can be used to investigate heat transfer associated with flow past cylindrical tubes either in isolation or

  Assuming an axial velocity at the eye of the impeller an

a helicopter gas turbine requires an overall compressor p.r. of 101. this is to be obtained using a two-spool layout

  At a certain instant a valve is opened and mass flows from

compressed air is stored in a pressure bottle with a volume of 10 ft3 at 3000 psia and 140 f. at a certain instant a

  5 lbm of air is compressed in a piston cylinder assembly

5 lbm of air is compressed in a piston cylinder assembly from 1 bar 300k to 5 bar according to a polytropic process

  An office worker claims that a cup of cold coffee on his

an office worker claims that a cup of cold coffee on his table warmed up to 80degc by picking up energy from the

  Simutaneously the coolant carries the heat away from the

a shell and tube heat exchanger consists of a tubecarrying a fluid to be heated or cooled surrounded by another fluid

  Compare the pressure force exerted on the face of two dams

Fluid/Dam Pressure, Compare the pressure force exerted on the face of two dams that hold a fresh water of 1000 Kg/m^3 density and a salty water of 1030 Kg/m^3

  You are designing a centrifugal compressor system to

you are designing a centrifugal compressor system to compress filtered atmospheric air at 101 kpa absolute to 750 kpa

  Briefly explain the difference between fatigue striations

Briefly explain the difference between fatigue striations and beachmarks in terms of both size and origin.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd