A rotor is being designed for a wind turbine

Assignment Help Mechanical Engineering

Reference no: EM13701042

A rotor is being designed for a wind turbine. The rotor will have a diameter of D = 70 m. A single airfoil will be used for the length of the blades. The airfoil has its minimum drag to lift ratio when the lift coefficient is 1.0. Two options are being considered for the wind turbine. The first is an optimum rotor (including wake rotation) with two blades. Its design tip speed ratio is 10. The other is an optimum rotor with three blades. Its design tip speed ratio is 7. Find chord of the blade for each rotor in steps of 0.05R, beginning at 0.1R. Find the solidity of each rotor.

Reference no: EM13701042

Questions Cloud

A hollow cylinder made of copper has an outer diameter : A hollow cylinder made of copper has an outer diameter of 200 mm, an inner diameter of 50 mm and a height of 100 mm. Under load P the final height of the cylinder is 60 mm and the inner diameter is 45 mm. If the strength coefficient K is 315 Mpa and ..

Heat conduction experienced by the person to the ice : A person with a uniform temperature of 29 C is standing barefoot on a block of ice in a breezy room at 20 C with an effective convection coefficient equal to 8 W/m^2 C. The surface area exposed to forced convection is 1.6 m^2.

What is the temperature and humidity of the outlet stream : A stream of air at 1 bar, 20 Â°C, 30% RH, at 100 m3/min is mixed with a stream of hot moist air at 120 Â°C, 75% RH, at 20 m3/min. What is the temperature and humidity of the outlet stream?

How did cincinnati zoo benefit from business intelligence : How did the Cincinnati Zoo benefit from business intelligence and how did it enhance operational performance and decision making?

A rotor is being designed for a wind turbine : A rotor is being designed for a wind turbine. The rotor will have a diameter of D = 70 m. A single airfoil will be used for the length of the blades. The airfoil has its minimum drag to lift ratio when the lift coefficient is 1.0. Two options are bei..

Size a suitable orifice plate to meter steady flow of water : Size a suitable orifice plate to meter the steady flow of water at 20 °C through 138 cm diameter pipe if the nominal flow rate expected is 200 kg/s and the pressure drop must not exceed 15 cm mercury.

What is the lattice constant of such a unit cell : In the textbook Sodium and Chlorine are listed as having ionic radii of 0.98 and 1.81 Å respectively. NaCl can form a face-cantered cubic unit cell. What is the lattice constant of such a unit cell?

What are the engine torque and power output : An internal combustion engine is driving an electrical dynamometer. The torque arm length is 0.5 m and the force is 200 N. A tachometer indicates that the shaft speed is 3490 rpm. What are the engine torque and power output?

Calculate the actual value of the measured temperature : A J-type thermocouple with an ice-reference junction showed a reading of 22 mV. After the experiment it was found that the actual temperature of the reference junction was 4 °C instead of 0 °C. Calculate the actual value of the measured temperature.

User Account

All Pages