Generate a table showing in the first column the mass values

Assignment Help Civil Engineering
Reference no: EM13303557

When exploring our solar system with probes or rovers, it is important to know the weight (force due to gravity) of the probe on the surface of the other planet so that, as an engineer, you can design the mechanical parts, e.g. the drivetrain for a rover, accordingly. The weight is calculated by using Newton's second law:

F=mg/gc

where:

F is the weight, lbf

m is the mass of the probe/rover, lbm

g is the local acceleration of gravity, ft/s^2 or m/s^2

gc is a constant, 32.174 (lbm-ft)/(lbf-s^2)

Write a MATLAB code that calculates the weight (forces due to gravity) in lbf on each planet of our solar system and earth's moon for probes/rovers which have a mass between 100 lbm and 300 lbm. Use increments of 20 lbm. Generate a table showing in the first column the mass values and the weights in the remaining columns.

Reference no: EM13303557

Questions Cloud

Determine largest distance d the concrete pipe may be moved : A crane is used to lift a concrete pipe weighing 10kN into place. For precision positioning, the worker at C can apply up a 800N force to cable AC. Determine the largest distance d the concrete pipe may be moved.
Liquidity on british petroleum : Select a company from the London stock exchange under FTSE 350 - Liquidity On British petroleum
Determine the temperature of the well water : The water in a deep underground well is used as the cold reservoir of a Carnot heat pump that maintains the temperature of a house at 294 K. Determine the temperature of the well water
What will rockwoods cost of equity capital be : If Rockwood finances their expansion by issuing new stock, what will Rockwood's cost of equity capital be?
Generate a table showing in the first column the mass values : Write a MATLAB code that calculates the weight (forces due to gravity) in lbf on each planet of our solar system and earth's moon for probes/rovers which have a mass between 100 lbm and 300 lbm. Use increments of 20 lbm.
Estimate the velocity of the object : An object oscillates in 1-D with an amplitude of 10 cm. At t = 0 s, its position is x = - 5 cm, What is the velocity of the object
If the economy were experiencing high rates : If the economy were experiencing high rates of unemployment and low inflation, the appropriate monetary policy strategy would most likely be: a. to have the Fed sell securities on the open market.
What is the tension in the left side string : A 20.0-kg mass is supported by two strings. The left string is 2.00 m long and the right string is 5.00 m long. What is the tension in the left side string
Determine magnitude of unbalanced force acting on particle : The path of motion of a 7-lb particle in the horizontal plane is described in terms of polar coordinates as r= (3t+2) and theta=(0.2t^2-t) , where t is in seconds. Determine the magnitude of the unbalanced force acting on the particle when t=3s.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Problem regarding helium balloons

To float a 160 pound man using helium balloons (assume 0.52 cubic feet per inflated balloon). How many balloons would it take? Assume density of air is 1.29 kg/cubic meter and the density of helium is 0.179 kg/cubic meter.

  What would be the corresponding increase in kinetic energy

A "slap shot" in the game of hockey can cause an increase in the velocity of a 5 oz puck from 2 ft/sec to 110 ft/sec. What would be the corresponding increase in the kinetic energy (ft-lb) of the puck.

  What percentage of removal should be expected for particles

Assume the settling tank behaves like an ideal sedimentation tank, what percentage of removal should be expected for particles with a settling velocity of 0.002 m/sec

  What is limiting depth of the exacavation to avoid heaving

An excavation is proposed for a site consisting of a homogenous, isotropic later of silt clay, 14.24 m thick, above a deep deposit of sand. The groundwater is 2m below ground level outside the excavation. The groundwater level inside the excavatio..

  How to label turing points numerically starting with tp1

A differential leveling loop started and closed on BM Juno, elevation 5194.02 ft. The BS and FS distancces were kept approximately equal. Readings (in ft) listed in the order takken are 9.65, 2.11, 2.51, 8.35, 2.06, 9.25, 7.93, 2.83, 5.05, and 4.6..

  What was involved in the first far-reaching

what was involved in the first far-reaching, comprehensive study of Earth's oceans?

  Determine the maximum service load

Determine the maximum service load W (kips) at the mid-height of the beam-column shown in the accompanying figure 2.1. Assume the member is hinged with respect to bending in both x and y directions at the top and bottom.

  Determine the angular acceleration of the spool

determine the angular acceleration of the spool and the acceleration of the trailer. The wheels have negligible mass and are free to rotate.

  Determine the maximum shear stress at the end

A 600 mm long solid steel shaft is to transmit a torque of 30 N-m, G=90 GPa, diameter 15mm. Determine (a) Maximum shear stress, and (b) Angle of twist (phi) at the end.

  Explain how to draw v-t and x-t curves of industrial planer

The velocity of the bed is limited to a maximum value of 150 mm/s to the right and 300 mm/s to the left; the acceleration is successively equal to 150 mm/s^2 to the right, zero 150 mm/s^2 to the left, zero, etc.

  Draw the influence line for the support reaction

Draw the influence line for the support reaction at A and calculate the support reaction at point

  Define base isolation technique has become the method

Base isolation technique has become the method of choice for structural design of buildings and bridges located in highly seismic areas in recent years.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd