Footings for a structure are to be built beneath a basement

Assignment Help Civil Engineering
Reference no: EM13530560

Footings for a structure are to be built beneath a basement slab on a clay at a depth of 20 ft. below present ground level. Representative consolidation tests on the soil produce a 0.043 slope of recompression curve. The groundwater table is 15 ft. below the ground surface. The soil has a unt weight of 120 pcf. The soil-void ratio is about 0.87. If the average bearing pressure on the footings is 2,600 psf., estimate the settlement of 10 ft. and 5 ft. square footings. Also , what is the factor of safety for the footings against bearing failure if the clay soil has an unconfined compressive strength of 3,600 psf? The back of the book says that for a 5 ft. footing, the estimated settlement= 1.72 in. And for a 10ft. footing, the estimated settlement= 2.42 in. Also it says the Factor of Safety at least for the 5 t. footing is FS=5.554. I need to be able to show step by step solution.

Reference no: EM13530560

Questions Cloud

Find the equivalent capacitance of the two capacitors : A 1.08 µF capacitor is connected in series with a 2.18 µF capacitor. The 1.08 µF capacitor carries a charge of +11.1 µC on one plate, Find the equivalent capacitance of the two capacitors
Explain how many bricks must incorporated into the interior : The specific heat of the brick is 0.85 J/g-K. How many bricks must be incorporated into the interior of the house to provide the same total heat capacity as 1.1 103 gal of water
Equilibrium temperature of the two bodies : What is the final equilibrium temperature of the two bodies?
Calculate the net entropy change of the system : A 15.0-kg block of ice at 0 °C melts to liquid water at 0 °C inside a large room that has a temperature of 20.0°C. Calculate the net entropy change of the system
Footings for a structure are to be built beneath a basement : Footings for a structure are to be built beneath a basement slab
Compute the ph of a solution of butyric acid : Butyric acid, HC4H7O2, has a Ka of 1.51 x 10^-5. Calculate the pH of a solution of butyric acid where 15.2 g of the acid was added to water to make 1.5 liters of solution.
What will be the phenotypic ratio of an F1 cross : What will be the phenotypic ratio of an F1 cross of fliescarrying two mutations if:
What is the value of electricity produced by this battery : Batteries are rated in terms of ampere-hours (A · h). For example, a battery that can produce a current of 2.00 A for 3.00 h is rated at 6.00 A · h. At $0.0830 per kilowatt-hour, what is the value of the electricity produced by this battery
Explain what is the ph of the solution naoh has been added : When 40 mL of 0.500 M HCl is titrated with 0.600 M NaOH, the pH increases. What is the pH of the solution after 33 mL of 0.600 M NaOH has been added. (assume volumes are additive)

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what external force is required to hold the bend

A pipe 1ft in diameter bends through an angle of 135 degrees. The velocity of flow of gasoline ( S = 0.8) is 20ft/s and the pressure is 10psig in the bend. What external force is required to hold the bend against the action of the gasoline

  Estimate convective heat transfer coefficent for natural

Estimate the convective heat transfer coefficent for natural convenction from a horizontal steam pipe. The outside surface temperature of the insulated pipe is 80 degree C. The surrounding air temperature is 25 degress C.

  What is limiting depth of the exacavation to avoid heaving

An excavation is proposed for a site consisting of a homogenous, isotropic later of silt clay, 14.24 m thick, above a deep deposit of sand. The groundwater is 2m below ground level outside the excavation. The groundwater level inside the excavatio..

  Determine the discharge in the channel in m3 per s

A very long rectangular channel connects two reservoirs and has a longitudinal slope of 0.005. The channel has a width of 10 m and a Manning's n of 0.030.

  What are the recorded values of r dot and r double dot

at the bottom of a loop in the vertical plane an airplane has a horizontal velocity of 315 mi/h and is speeding up at a rate of of 10ft/s^2. The radius of curvature of the loop is 1mi. The plane is being tracked by radar at O.

  Determine the force n exerted by the fixed circular slot

At the instant when angle theta= 50 degree, the horizontal guide is given a constant upward velocity v0 = 1.3 m/s. For this instant calculate the force N exerted by the fixed circular slot and the force P exerted by the horizontal slot on the 0.60..

  What is the pressure inside the glass

A glass is cleaned in 45 0C hot water and placed onthe table bottom up. The room air at 20 0C thatwas trapped in the glass gets heated up to 40 0C andsome of it leaks out so the net resulting pressure inside is 2 kPaabove ambient pressure of 101 kPa...

  Calculate the relative compaction

A dam project specifies 97% compaction. Lab tests on the soil being used indicate that it has a maximum dry density of 1900 kg/m3 at an optimum water content of 13.2%. Field tests give the following results: Field dry density is 1790 kg/m3 and 16...

  What would the spindle diameter need to be in order to move

The crane hoists a uniformly distributed load C. the two identical motors at A an power through gearboxes operating at maximum output speed of 100 rpm.the load is lifted by winding cable onto spindles attached to the output shaft of each gear box.

  What is ma the moment that tends to twist the telephone

An old wooden telephone pole with a single cross member was blown off center during a recent storm. To temporarily stabilize the telephone pole, a repair crew has attached a cable from the end of the cross member to an eye-ring stake anchored in t..

  Determine what force was needed to buckle the bar

On a very hot day, I saw a 1.6 meter long steel bar held between two rigid supports that had buckled due to the heat. The bar had a cross section of 10 mm by 40 mm, and I assume was A36 steel.

  What is the difference between factor of safety

what is the difference between factor of safety in rankine & coulomb in overturning, sliding and bearing capasity ?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd