User Account

All Pages

Fine pearlite and a small amount of martensite are found

Assignment Help Mechanical Engineering
Reference no: EM13631263

Fine pearlite and a small amount of martensite are found in a quenched 1080 steel. What microstructure would be expected if we had used a low alloy, 0.2% C steel? What microstructure would be expected if we had used a 4340 steel?

Reference no: EM13631263

Questions Cloud

You are to design and produce a 2 inch thick steel wear : you are to design and produce a 2 inch thick steel wear plate for a rock-crushing unit. to avoid frequent replacement
An ideal reheat rankine cycle with water as the working : an ideal reheat rankine cycle with water as the working fluid operates the inlet of the high-pressure turbine at 8000
As used in the laws of reflection and refraction what is : 1 as used in the laws of reflection and refraction what is the definition of the normal direction?2 the refraction
Draw the p-v and t-s diagrams of the cycle and determine a : a variable specific-heat air cycle in a closed system is composed of the following four processesprocess 1-2 isentropic
Fine pearlite and a small amount of martensite are found : fine pearlite and a small amount of martensite are found in a quenched 1080 steel. what microstructure would be
The gas may be considered idal at these conditions find : two cubic feet 2 ft3 of air is compressed slowly from 1 atm and 80 degrees f to a pressure of 10 atm. the gas may be
Aditional heat is added until the pressure reaches 12 mpa : two kilograms of water are contained in a pistoncylinder arrangement. the massless piston is loaded with a linear
A dam across a river dams up a lake 300 m higher than the : a dam across a river dams up a lake 300 m higher than the river downstream. the electric generators driven by
The vessel will rupture if the pressure reaches 5 mpa what : 15 kilograms of water are confined in a rigid vessel with a volume of 0.5 m3 with an intitial temperature of 50

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Find the direction and magnitude of the work done this

a cylinder is confined in a cylinder by a spring-loaded frictionless piston so that the pressure in the fluid is a

  Determine the maximum lift force provided by the pump

the velocity of a lift increases uniformly from zero to its maximum value at mid-height (1.4m) in 7.5s and then decreases uniformly to zero in 7.5s. The peak power output is 6kW when the velocity is maximum, determine the maximum lift force provid..

  How many kilograms each of pearlite and the proeutectoid

How many kilograms each of pearlite and the proeutectoid phase form? Schematically sketch and label the resulting microstructure.

  A 31-l electric radiator containing heating oil is placed

a 31-l electric radiator containing heating oil is placed in a 48-m3 room. the room and the radiator oil are initially

  Consider a steam power plant with reheat that operates on a

consider a steam power plant with reheat that operates on a modified rankine cycle. steam enters the high-pressure

  What is the temperature and state of the steam in the pipe

a) What is the temperature and state of the steam in the pipe? b) What is the quality of the steam in the pipe?

  Find an expression for a change in enthalpy during a

for a gas which obeys equation of state pv-b rt where b is constant a find an expression for a change in enthalpy

  Dtermine the mass rate of water flowing kgs height

a 5 cm orifice meter is being used to measure the flowrate of 70 degree c water. the mercury manometer shows a height

  A closed system contains 2kg of air undergoes an isothermal

1 a piston-cylinder device contains air initially at 150kpa 20oc and 0.5m3. the air is now compressed in a polytropic

  Design a computer programme using freudestein equation

design a computer programme using freudestein equation to synthesise a four bar linkage using three precision points also using more than three points.

  Air at a pressure of 400kpa and a temperature of 700 degree

air at a pressure of 400kpa and a temperature of 700 degree celsius expands in a turbine at steady state to a pressure

  A pison-cylinder contains 08 kg of steam of 300oc and 1

a pison-cylinder contains 0.8 kg of steam of 300oc and 1 mpa. the steam is cooled at constant pressure until one-half

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd