Find the volume occupied by saturated liquid

Assignment Help Mechanical Engineering
Reference no: EM13705974

Propane at 8 bars and 80oC is contained in a closed, rigid vessel with a volume of 10 m3. Its temperature drops due to heat transfer to the surroundings. Determine (a) the temperature at which condensation first occurs and (b) the fraction of the total mass that has condensed when the pressure reaches 5 bars. Also, find the volume occupied by saturated liquid (in m 3 ) when the pressure reaches 5 bars.

Reference no: EM13705974

Questions Cloud

Constant pressure until piston regains its original position : A cylinder contains 1 kg of a certain fluid at an initial pressure of 20 bar. The fluid is allowed to expand reversibly behind a piston according to a law PV^2=constant until the volume is doubled. The fluid is then cooled reversibly at constant pres..
Water flows through the pipe at a constant average velocity : Water flows through the pipe at a constant average velocity of 0.5 m/s into the the tank having the width of 1.5 m. Determine the relation between the time needed to fill the tank to a depth of h = 3 m and the diameter D of the pipe at. Plot the time..
Calculate the work done by the fluid on the piston : A fluid at a pressure of 3 bar, and with specific volume of 0.18 m^3/kg, contained in a cylinder behind a piston expands reversibly to a pressure of 0.6 bar according to a law, Pv^2=C, where C is a constant. Calculate the work done by the fluid on th..
Constant-temperature compression to volumetric : A sealed piston-cylinder assembly contains 3 lbm of water. The water is initially at P1 = 40 psia and T1 = 300°F. The water undergoes two processes in series: Constant-temperature compression to Volumetric = 11.19 ft3, during which the water transfe..
Find the volume occupied by saturated liquid : Propane at 8 bars and 80oC is contained in a closed, rigid vessel with a volume of 10 m3. Its temperature drops due to heat transfer to the surroundings. Determine (a) the temperature at which condensation first occurs and (b) the fraction of the tot..
Efficiency closer to the corresponding carnot cycle : An Otto cycle and a Carnot cycle working between the same maximum and minimum temperature limits does not have the same efficiency, nor does a Rankine and the corresponding Carnot cycle have the same efficiency.
Short cylinder whose top and bottom surfaces are insulated : Consider a short cylinder whose top and bottom surfaces are insulated. The cylinder was initially at a uniform temperature of Ti. At time t=0, the cylinder is suddenly subjected to a convection from its side surface to a surrounding fluid at temperat..
Determine the specific volume at the indicated state : For each case, determine the specific volume at the indicated state. Locate the state on a sketch of the T-v diagram.
Determine the specified property data at the indicated state : Using the tables for water, determine the specified property data at the indicated states. In each case, locate the state on sketches of the p-v and T-v diagrams.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  An air-water vapor mixture enters an adiabatic saturator at

an air-water vapor mixture enters an adiabatic saturator at 30 degree c and leave at 20 degree c which is the adiabatic

  A damping ratio of 08 determine a the dynamic error when

a strain gage system is mounted on an airplane wing to measure wing oscillations and strain during wind gusts. the

  The system undergoes a polytropic process resulting in the

a closed system contains 0.8 kg of air initially at 155 kpa with a volume of 0.45 m3. the system undergoes a polytropic

  A cylinderpiston contains carbon dioxide at 1 mpa 300oc

a cylinderpiston contains carbon dioxide at 1 mpa 300oc with a volume of 200 l. the total external force acting on the

  Determine the power requirement w and volumetric flow rate

a refrigerator uses a compressor that employs r-134a as the refrigerant. determine the power requirement w and

  Determine the heat transfer and work for both processes

2.2 lb of ammonia in a piston cylinder assembly undergoes two isothermal processes in series. The first process from an initial state where p1=120lbf/in^2 with a quality is 85% to a final state where the ammonia is saturated vapor. D

  Determine the maximum shear stress in the shaft

A 40 mm diameter hole is drilled 3 m deep into the steel shaft. When the two torque are applied, determine (a) the maximum shear stress in the shaft: and (b) the angle of rotation of the free end of the shaft. Use G= 83GPa for steel.

  Assuming no slip conditions and that the system is

because of poor lubrification the pulley must overcome a constant friction moment of 12 nm as it rotates. assuming no

  How many phases will be present in the al-mg alloy at room

design an al-si brazing filler alloy that will be used to join an al-mg alloy. the al-mg alloy has a solidus

  Liquid in a tube varies with tube diameter

The capillary rise, h, of a liquid in a tube varies with tube diameter, d, gravity, g, fluid density, roe , surface tension, Y, and the contact angle, B. (a) Find the dimensionless form of this statement. (b) If h = 3 [cm] in a given experiment, what..

  Refrigerant 134a enters an adiabatic compressor as

refrigerant 134a enters an adiabatic compressor as saturated vapor at 200kpa at a rate of 30 kgmin and is composed to a

  If the temperature of the sample changes from 60 degc to 50

a resistance-based thermometer is commonly used in the industry to measure temperature. when the temperature of the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd