Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The initial piezometric head in a confined aquifer has a thickness of 11.6 m is 85.7 m above sea level. A well with a radius of 0.5 m pumps at a constant rate of 1240 m3/day. After the cone of depression has achieved equilibrium, the piezometric heads at two observation wells 40 and 95 m from the pumping well are measured as 78.9 and 83.4 above sea level, respectively. Also, the piezometric head in the pumping well during equilibrium remains at 46.6 m.
Determine (a) the aquifer transmissivity,
(b) the radius of influence of the pumping, and
(c) the total well losses in and around the pumping well.
A 110 cm^3 sample of wet soil has a mass of 106 g and a degree saturation of 100%. When oven-dried, the mass is 81 g. Determine the 1) water content, 2) specific gravity, 3) void ratio, and unit dry weight of soil particles.
The bolts have a mean diameter of 1.000 cm, normally distributed with standard deviation of 0.010 cm. The holes have a mean diameter of 1.030 cm, normally distributed with standard deviation of 0.015 cm.
a wheel tractor scraper weighing 100 tons is being operated on a haul road which is now packed. this tractor is traveling fully loaded up a 6% slope to the dump site which is 0.5 miles away. the return trip is level and is also 0.5 miles away.
The Three Gorges Dam in China will be the world's biggest when complete. When did the construction start
The motor-generators installed with these pump-turbines have an efficiency of 0.85 when operating as motors and 0.91 when operating as generators. Each pump-turbine uses its own 100-m-long, 150-cm steel penstock.
Devise an absolute temperature scale where the boiling point of water at 1 atmosphere (101 kPa) pressure = 100 degrees in your scale. What is the ice point of water in your scale
An overhanging beam ABC is subjected to a couple MA at the free end (see figure). The lengths of the overhang and the main span are a and L, respectively. Determine the angle of rotation and deflection at end A.
Estimate the steady state PM10 concentration assuming a PM10 deposition velocity of 0.12 cm/s, prevailing wind velocity of 2.5 m/s, and a constant emission flux of PM10 0.82 mg/m2-s.
A sample of natural glacial till was taken from below the groundwater table. The water content was found to be 52%. Estimate the wet density, dry density, buoyant density, porosity and void ratio. Clearly state any necessary assumptions.
1. The three isometric axes are: vertical and two axes 30 degrees from horizontal. 2. Oblique projection is a perspective projection method. 3. Isometric view represents a parallel projection method.
how to calculate the principle of shoring system in formwork analysis when the secondly floor upper has been poured ?
CPM Construction plans to buy a truck for $150,000 and sell it for $15,000 at the end of 5 years. The annual operating cost of the vehicle is $60,000. What is the present value of the truck
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd