Find the time taken for the depth to empty completely

Assignment Help Civil Engineering
Reference no: EM13322931

a rectangular swimming bath is 1m deep at one end and increases uniformly in depth to 2.6m at the other end . the bath is 8m wide and 32m long and is emptied through an orifice of 0.2m^2 at its lowest point. assuming there are no losses at the orifice , find the time taken for :
a)the depth to fall by 1m
b)the depth to empty completely.

Reference no: EM13322931

Questions Cloud

Determine the viscosity of the fluid at a distance : Two parallel plates are separate at a distance of 2mm by a fluid. If a shearing stress of 150 Pa is developed at the upper plate when it is pulled at a velocity of 1m/s. Determine the viscosity of the fluid.
Write an inheritance hierarchy for classes quadrilateral : Write an inheritance hierarchy for classes Quadrilateral, Trapezoid, Parallelogram, Rectangle and Square. Use Quadrilateral as the base class of the hierarchy.
The day the machines went off : The Day the Machines Went off
What rate of perspiration would be needed to maintain a skin : Considere a person who consumes 2100 kcal par day, of which 2000 kcal is converted tu hermal energy.( the remaining 100 kcal is used to do work on the environment.) The person has a surface area of 1.8 m² and is dressed in a bathing suit.
Find the time taken for the depth to empty completely : a rectangular swimming bath is 1m deep at one end and increases uniformly in depth to 2.6m at the other end . the bath is 8m wide and 32m long and is emptied through an orifice of 0.2m^2 at its lowest point.
Briefly summarize the outcome for hours of work : Briefly summarize the outcome for hours of work, total weekly income, and Steve's total utility.
Compute and print the average power output : Compute and print the average power output over this 10-week period. Print the number of days with greater-than-average power output.Also print the day of the week and the number of the week on which the output is greater-than-average.
What may be the value of the load to the beams own weight : A high-strength steel simply supported W24 X 76 beam carries a uniformly distributed load over its entire length of 25 ft. (a) If the allowable stress is 33 ksi, what may be the value of the load, in addition to the beam's own weight
Explain organic compound from an aqueous solution : When extracting an organic compound from an aqueous solution into an organic solvent, e.g., diethyl ether, a chemist will sometimes add sodium chloride to the aqueous solution. What is the purpose of such an addition, and what is the procedure cal..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Comparative analysis of the types of safeguards

Provide a comparative analysis of the types of safeguards would you suggest for the company's information system.

  Determine the required length of splice to be lap spliced

number 9 compression bars in a column are to be lap spliced. there is no excess steel, and the bars are enclosed by a spiral of 3/8 inch diameter wire having a pitch of 3 inch.

  Will the quantity of coarse aggregate increase or decrease

Compute the required weight of coarse aggregate per cubic yard. to adjust the mix so as to increase the compressive strength, the water-to-cement ratio is reduced to 0.45. will the quantity of coarse aggregate increase, decrease, or stat the same

  Determine how many bits wide is the main memory data bus

A MIPS-based computer system with 2 GB of main memory that is built on a single circuit board. It is designed with a single control signal between the CPU chip and main memory, i.e. one bit of control that is set to one for Read operations

  Determine normal stresses induced in steel and in concrete

The concrete post (Ec=3.6*10^6 psi and Ac= 5.5*10^-6/degrees F) is reinforced with six steel bars. each of 7/8-in diameter (Es=29*10^6 psi and As=6.5*10-6/ degrees F).

  Discuss the different environmental companies

Discuss the different agencies, institutes, centers, different environmental companies that are active in UAE.

  Find the velocity at which shuttle hits the player bs racket

In Singles badminton game, shuttle is smashed by Player A from close to base line, which is 6 m from the net. Height of the net to be cleared by a smash is 1.55 m. The shuttle is hit by player A at a speed of 250 km/h.

  What is the rate of heat removal from the surroundings

Heat transfer through the walls and roof is estimated to be 5 40 kJ/hr per degree temperature difference between the inside and outside. a. If the outside temperature in the winter is - 5 C, what power required to drive the heat pum p (kJ/hr

  How much work is required to pump all of the water

A circular swimming pool has a diameter of 18 m, the sides are 3 m high, and the depth of the water is 2.5 m. How much work (in Joules) is required to pump all of the water over the side

  What is the magnitude and direction of the resultant force

The bend lies in a horizontal plane, and water enters from the west and leaves toward the north. Assuming no drop in pressure, what is the magnitude and direction of the resultant force acting on the bend

  Compute degree of saturation-water content and void ratio

A sample of moist soil has a volume of 40.5 cc mass weight of 59.2 gms. After drying it has a mass weight of 48.3 grams. The specific gravity of the solids are 2.68.

  What is the angle of inclination of the plane

A body slides down a frictionless plane and during the third second after starting from rest if it travels 20.4m. What is the angle of inclination of the plane?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd