Find the steady-state concentration to be completely mixed

Assignment Help Civil Engineering
Reference no: EM13321054

Consider the air over a city to be a box 100 km on a side that reaches up to an altitude of 1.0 km. Clean air is blowing into the box along one of its sides with a speed of 4 m/s. Suppose an air pollutant with rate constant k= 0.20/hr is emitted into the box at a total rate of 10.0 kg/s. Find the steady-state concentration if the air is assumed to be completely mixed.

Reference no: EM13321054

Questions Cloud

Determine substrate concentration and biomass concentration : how to determine the substrate concentration and biomass concentration at 0.5 days. Use spreadsheet to solve for the concentrations with a delta t = 0.01 days
Explain what are the concentrations of nad+ : what are the concentrations of [NAD+] and [NADH] in the cells? Under oxidative stress condition, the cellular redox potential is shifted to -290 mV. What will be the concentrations of [NAD+] and [NADH] in this cell under this oxidative stress cond..
What potential is generated on a planes wings : What potential is generated on a plane's wings when it flies through the earth's magnetic field
Determine rate of ammonia utilization nd biomass growth rate : Determine the rate of ammonia (NH4-N) utilization and the biomass growth rate for the following conditions: µm = 0.50 g VSS/g VSS-d Ks = 0.50 mg/L X = 10 mg/L S = 40 mg NH4-N/L
Find the steady-state concentration to be completely mixed : Suppose an air pollutant with rate constant k= 0.20/hr is emitted into the box at a total rate of 10.0 kg/s. Find the steady-state concentration if the air is assumed to be completely mixed.
Estimate the work done on the gas : In a certain experiment, the pressure of a gas depends on the volume by P=alphaV^3+betaV^2, What is the work done on the gas
Explain molecular formula of the compound : What are the empirical formula and the molecular formula of the compound.
Analysis of business needs and requirements : Analysis of Business Needs and Requirements.
Determine what pressure must be provided at point 1 : To maintain a pressure of 300kPa at point 2, what the 15 C water is flowing at 0.5 L/s, what pressure must be provided at point 1 if you neglect friction

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the ratio of area to volume for unit cube

calculate the ratio of area to volume for unit cube a unit sphere in inscribed inside the cube, and as write cylinder inscribed inside the cube.

  Determine what is the departure of the course

A course has true azimuth of 157 degrees 15 minutes and a length of 325 feet. What is the departure of the course

  Explain how to determine the normal stress in rod ad

If the temperature of rod CF is increased by 10 degrees C and that of rod BC is decreassed by 40 degrees C, determine the normal stress in rod AD. The rods are two meters long.

  Determine the daily discharge of groundwater into the canal

A canal is constructed parallel to a river 600 m away both fully penetrating an unconfined aquifer of coarse sand and fine gravel as shown in the illustration below. The aquifer is subject to an average infiltration of 2.3 m/year

  Determine magnitude of velocity and acceleration of particle

The motion of a particle on the surface of a right circular cylinder is defined by the relations, R = A, theta = 2pi(t), and z=Bsin(2pi)(nt), where A is a constant. Determine the magnitudes of the velocity and acceleration of the particle at any t..

  Estimate the hydraulic retention time if the reactor is pfr

A biological reactor is used to treat wastewater from a small community (Q = 100,000 gpd). The influent BOD5 concentration to the reactor is 200 mg/L and the required effluent BOD5 concentration is 30 mg/L.

  Determine the percent overload if load estimate is correct

A customer estimates that he is getting 30 cubic yards (loose) of gypsum in his scraper. Determine the percent overload if the load estimate is correct. The maximum load capacity of the scraper is 84,000 pounds.

  What is lowest grade possible for the constant-grade section

A tangent section of highway has a -1.0% grade and ends at station 4+75 and elevation 82 ft. It must be connected to another section of highway that has a -1% grade and that begins at station 44+12 and elevation 131.2 ft.

  Estimate the mean and standard deviation of time

The probability density function, f(t), of the time in hours between storms during the summer in Miami is estimated as f(t) = .014e^(-.014t) if x > 0, f(t) = 0  if x is less than or equal to 0 where t is the time interval between storms in hours.

  Determine how particle moves along horizontal straight line

A particle moves along a horizontal straight line with a constant acceleration of 5 meters per second squared to the left. The particle starts with a velocity of 10 meters per second to the right.

  Determine the speed before the plunger strikes the stop

If the arm is pulled back such that s= 100 mm and released, determine the speed of the 0.41-kg pinball B just before the plunger strikes the stop, i.e., s= 0. Assume all surfaces of contact to be smooth.

  Determine what is ow rate of sea water through the tunnel

Google budgets for an energy consumption of the pump for this system of 2MW. If the pump 1 has an efciency of n= 87%, what is the ow rate of sea water through this tunnel

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd