Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Three new cast iron pipes, having diameters of 24, 21 and 18 in respectively, each 450-ft long, are connected in series. The 24-in pipe leads from a reservoir (flush entrance), and the 18-in pipe discharges into the air at a point 15 ft lower than the reservoir water surface level. Assuming all changes in section to be abrupt, find the rate of discharge of water at 60 degrees Fahreneit.
An old wooden telephone pole with a single cross member was blown off center during a recent storm. To temporarily stabilize the telephone pole, a repair crew has attached a cable from the end of the cross member to an eye-ring stake anchored in t..
The stationary disk, of 300 mm radius, is attached to a pin support at D. The disk is held in place by the brake ABC in contact with the disk at C. The hydraulic actuator BE exerts a horizontal 400 N force on the brake at B.
The pressure at the entrance of the system must be at least 75 psi and the demand is 1350 GPM. The pipe material is to be riveted steel and the length of pipe is 5,000 feet. What size pipe should be used
The potentiometric surface elevations at two observation wells 1000 m apart are 52.35 m and 56.90 m. If the horizontal hydraulic conductivity of the auquifer is 25 m/ day determine the specfic discharge, and average linear veolicity of the flow as..
A worker needs to enter a confined space to tighten the packing on a leaking argon valve. Describe two procedures that could be used to isolate the argon line and valve prior to starting work.
A small building that shelters a water supply pump measures 2 m x 3 m x 2.4 m high. It is constructed of 1- cm thick wood having a thermal conductivity of 0.126 W*m^-1*K^-1.
The cables A and B exert forces FA and FB on the hook. The magnitude of FA is 100 lb. The tension in cable B has been adjusted so that the resultant of the two forces is oriented perpendicular to the wall to which the hook is attached.
The wedge is used to level the member. Determine thehorizontal force P that must be applied to move the wedge to theright. The coefficient of static friction between the wedgeand the two surfaces of contact is ts=.25.
The velocity along a pathline is given by V (m/s) = s^2 x t^(1/2) where s is in meters and t is in seconds. The radius of curvature is 0.5 m. Evaluate the acceleration along and normal to the path at s = 2m and t = 0.5 seconds.
Determine the horizontal and vertical components of reaction at the pin supports at A and B and indicate direction. Take F1 = 7 KN, F2 = 6 KN, and h = 1 m.
Pore water pressure is to be observed during the construction of the embankment. Calculate the pore water pressure which must not be exceeded at any point in the clay layer 9 m below the surface of the embankment to ensure a shear strength of 100 ..
Two simply supported beams are coupled so their centers have equal deflections. The upper beam has length L1 and lower beam has length L2. Determine the deflection of the center of the beams.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd