User Account

All Pages

Find the mole fraction and mass fraction of each component

Assignment Help Civil Engineering
Reference no: EM13312427

A gaseous mixture of carbon monoxide, carbon dioxide, methane and nitrogen gas is analyzed with a gas chromatograph (GC). The output takes the form of a series of peaks where each peak corresponds to a component and a peak area (A) is proportional to the moles (n) of the component ( n = kA) in the sample injected in the GC. Area of carbon monoxide is 22, the area of methane is 42, the area of carbon dioxide is 28. The molar ratio of nitrogen to methane is known to be 0.26. Find the mole fraction and mass fraction of each component, and the average molecular weight of the mixture,

Reference no: EM13312427

Questions Cloud

Find the maximum compression of the spring : A 3.40 kg block starts from rest and slides down a frictionless incline, dropping a vertical distance of 2.60 m, Find the maximum compression of the spring
Determine the equilibrium concentrations of a, b : Consider the following reaction: A(g)= B(g)+C(g) Find the equilibrium concentrations of A, B, and C for each of the following different values of Kc. Assume that the initial concentration of A in each case is 1.0 M
Provide guidance for federal government procurement : Describe the major regulations that regulate and provide guidance for federal government procurement.
What would the height of a water tower with a gallon tank : what would the height of a water tower with a 500 gallon tank have to be, to bring water ( by gravity ) from sealevel over a distance of 2.5miles with an elevation of 300ft
Find the mole fraction and mass fraction of each component : The output takes the form of a series of peaks where each peak corresponds to a component and a peak area (A) is proportional to the moles (n) of the component ( n = kA) in the sample injected in the GC.
Explain what is the equilibrium concentration of h3o+ : Consider the following reaction: HC2H3O2 (aq) + H2O (l) = H3O+ (aq) + C2H3O2- (aq) Kc=1.8*10^-5 at 25C If a solution initially contains 0.260M HC2H3O2, what is the equilibrium concentration of H3O+ at 25C
Determine factored uniform load per foot which beam supports : Structural steel beams are to be placed at 7ft 6in on center under a reinforced concrete floor slab. If they are to support a service dead load D=64 psf of floor area and a service live load L=100 psf of floor area
Explain what molarity of aqueous calcium chloride solution : What molarity of aqueous calcium chloride solution can be expected to show the same conductivity as 0.0050 M aluminum sulfate at 12,500 units.
Describe how a systematic recruiting process can be enhanced : Describe how a systematic recruiting process can be enhanced

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the ph of a 1-l solution containing sodium acetate

Calculate the pH of a 1-L solution containing 0.01 M sodium acetate after the addition of 3 mL 0.5 M H2SO4

  How much horsepower does the cyclist need to produce

A bicyclist travels on a level path. The frontal area of the cyclist and the bicycle is 2.3 ft^2 and the drag coeffcient is 1.2. The specific weight of the air is .075lb/ft^3.

  Calculate loads on floor and roof one way slabs

The proposed 4 story reinforced concrete office building including a green roof is to be constructed. The building is confirm to IBC 2006/2009 and ACI-318-11. 1) Calculate Loads on Floor and Roof one way slabs.

  Investigate the possibility of environmental problems

Investigate the possibility of environmental problems that faced by the area of disaster.

  Find outlet volumetric flow of toluene from the process

Saturated steam (at 20 bar) is used to heat up a toluene stream from 40oC, 1 bar to 150oC, 1 bar in a heat exchanger. The toluene stream is flowing at a rate of 100 kg/min. Steam leaves the heat exchanger as a saturated liquid at 20 bar.

  Determine the shear-thrust and moment in the arch at point c

The three hinged arch is composed of segments of a circle. Support points A and D are not at the same level.Determine: (a) the horizontal and vertical components of reaction at A and D.

  Find pipe diameter if the pressure drop is pa per m of pipe

air flows through a horizontal iron tube (e=0.15m) at Q=5.7x10-2 m3/s. find the pipe diameter if the pressure drop is 3.5kPa per 30.5m of pipe. air density = 1.23kh/m3 dynamic vicosity = 1.79 x 10-5 N.s/m2)

  Determine what is the pressure in cell that can be varied

Pure n-butane is contained in a laboratory cell in which the volume can be varied. The cell is maintained at a temperature of 200°F. The volume is changed until a few drops of liquid n-butane are present. What is the pressure in the cell

  Determine what is the pressure in the system in h2o

if a manometer incline at 45 degrees containing a fluid with specific gravity of a 2.0 using it to measure the pressure in a system, and the fluid levels rise 30 inches. What is the pressure in the system in Lbf/In^2 and H2O

  Determine the post construction vertical stress imposed

Determine the preconstruction and post construction vertical stress imposed on the soil at a point 2 m below the center of the foundation area (assume westergaard conditions applied)

  Find the shortest ladder

a wall 8 ft high is 3/3/8 ft. from a house. find the shortest ladder which will reach from the ground house when leaning to the wall.

  Simple curve having central angle problem

A simple curve has a central angle of 42 degreess. A point Y is located 24m from the vertex and has a perpendicular distance of 3.00m from the back tangent.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd