Find the maximum possible spacing between pumping station

Assignment Help Civil Engineering
Reference no: EM131310531

Crude oil flows through a level section of the Alaskan pipeline at a rate of 1.6 million barrels per day (1 barrel = 42 gallons). The pipe inside diameter is 120 cm, and its roughness has a characteristic dimension of 1.5 mm. The maximum allowable pressure is 8300 kPa, and the minimum pressure required to keep dissolved gases in solution in the crude oil is 350 kPa. The crude oil has SG = 0.93, and its viscosity at the pumping temperature is μ = 0.017 Ns/m2. For these conditions, determine the maximum possible spacing between pumping stations.

Reference no: EM131310531

Questions Cloud

Design a relational database so that it is at least in 3nf : Design a relational database so that it is at least in 3NF.Explain typical situations when denormalizing a table is acceptable. Provide one (1) example of denormalizing a database table to justify your response.Explain the significant manner in wh..
Security awareness metrics : Each phase of the security awareness program creation process is important. Design, development and implementation are all critical. However, the work does not end with implementation.
Determine the composition of the exiting liquid stream : Determine the composition of the exiting liquid stream; the ratio of the actual Ls/Gs is larger than the minimum Ls/Gs.
How long will it take the object to reach its maximum height : MATH233 Unit 2: Polynomial Functions- How long will it take the object to reach its maximum height? How long will it take the object to hit the ground? What is the velocity of the object when it hits the ground?
Find the maximum possible spacing between pumping station : The crude oil has SG = 0.93, and its viscosity at the pumping temperature is μ = 0.017 Ns/m2. For these conditions, determine the maximum possible spacing between pumping stations.
What decides to use tcp or udp : Network switches provide essential connectivity in local and wide area networks. Some of them run in multilayer between layers 2 and 3. What protocol unit is being used in layer 2?The backbone of the Internet is structured by the Internet Protocol ..
At what air speed should the model test be performed : The drag on a 2-m-diameter satellite dish due to an 80 km/h wind is to be determined through wind tunnel testing on a geometrically similar 0.4-m-diameter model dish.
Determine the moles of water that are required per mole : Determine the moles of water that are required per mole of H2S-free carrier gas if 1.5 times the minimum ratio will be used.
How fast must the wing move through the air : How fast must the wing move through the air at an altitude of 35,000 ft if it is to generate the same lift? (Assume the lift coefficient is constant.)

Reviews

Write a Review

Civil Engineering Questions & Answers

  Radioactive waste from a clinical laboratory

A radioactive waste from a clinical laboratory contains 0.2 μCi (microcuries) of calcium-45 (45Ca) per liter. The half-life of 45Ca is 152 days.

  Determine the pressure required to fill the container

If intake1=0m and intake2=0.5m, find the pressure required to fill the container when h=0.75m at both point 1 and 2. Assume the air is at atmospheric pressure until the water level passes intake 2 and the air follows isothermal compression.

  Calculate the bod loading and days of winter storage avail

Facultative stabilization ponds with a total surface area of 6.0 ha serve a community with a waste discharge of 530 m cubed/d at a BOD of 280 mg/l.

  Determine the volume flow rate of the water

A horizontal water jet impinges against a vertical flat plate at 25 ft/s and splashes off the sides in the vertical plane. If a horizontal force of 350 lbf is required to hold the plate against the water stream,

  What are the legal ways of doing disposal in the valley

A tank with a volume of 5,000 gal contains salt solution at an initial concentration (C0*) of 70,000 mg/L, but the concentration in the tank (C) needs to be reduced to 500 mg/L. Two approaches are being considered

  Construction and built environment sector

Describe in outline the main markets, activities and services provided by the construction and built environment sector.

  How will the operator change affect the oxygen requirement

an operator at a wastewater treatment plant decided to increase the SRT from 5 days to 10 days. How will this change affect: a) the oxygen requirement b) MLVSS in the aeration tank.

  Estimate the power expected to be delivered by model turbine

Estimate the power expected to be delivered by the model turbine.

  Determine to what depth will the balloon sink

A 2.0-ft^3 object weighing 650 lb is attached to a balloon of negligible weight and released in the ocean (γ = 64 lb/ft^3). The balloon was originally inflated with 5.0 lb of air to a pressure of 20 psi.

  What is the anle of internal friction for the sand

A direct shear cell 25.4cm x 25.4 cm in plan is filled with dry sand. a normal load of 6kN is applied to the sample, and the shear failure is 3.5kN. What is the anle of internal friction for the sand?

  Find the total bulb power in w total bulb power lost as heat

Where: Q is the amount of energy added (joules) M is the mass of the fluid (kg) C (subscript p) is the heat capacity of the fluid (joules/kg/K), and Delta T is the change in temperature (K or C degrees) A garage (24 ft x 24 ft x 10 ft) is illuminated..

  Determine the required cross sectional area of the cables

A steel plate which is 1.5 m by 1.5 m and 30 mm thick is lifted by four cables attached to its corners that meet at a point that is 2 m above the plate. Determine the required cross sectional area of the cables

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd