Find the magnitude of the force on one side of plate

Assignment Help Civil Engineering
Reference no: EM13300461

A rectangular plate 5ft by 4ft is at an angle of 30 degrees with the horizontal, and the 5-ft side is horizontal. Find the magnitude of the force on one side of the plate and the depth of its center of pressure when the top edge is (a) at the water; (b) 1 ft below the water surface

Reference no: EM13300461

Questions Cloud

Define in detail the ph at the equivalence point : What volume of base, in milliliters, is required to reach the equivalence point? (c) What is the pH at the equivalence point.
Compare the spring constants of the two springs : A certain amount of work is required to stretch spring A a certain distance. Compare the spring constants of the two springs
Determine at what time does the minimum volume occur : The inflow to a small reservoir during a storm may be described by the equations Q=1000(1-e^-kt) where Q= flow in cfs k= runoff rate = 1.0 per hour t = time in hours The outflow through the dam gates is held constant at 800 cfs.
Find the total work done on the skateboarder : A 65 kg skateboarder comes over the top of a hill at 5.0 m/s and reaches 10 m/s at the bottom. Find the total work done on the skateboarder
Find the magnitude of the force on one side of plate : A rectangular plate 5ft by 4ft is at an angle of 30 degrees with the horizontal, and the 5-ft side is horizontal. Find the magnitude of the force on one side of the plate and the depth of its center of pressure when the top edge is (a) at the wate..
Experiences of free blacks in early nineteenth-century : Which of the following statements most accurately characterizes the experiences of free blacks in early nineteenth-century United States?
How far does the spring stretch : You do 6.5 J of work to stretch a spring with k = 190 N/m , starting with the spring unstretched. How far does the spring stretch
Explain bond energies to estimate enthalpy changes : Use average bond energies to estimate enthalpy changes for C(s) + CO2(g) -----> 2CO(g) i got -221 kj/mol, but it was the wrong answer though.
Find which is in the audible range of frequencies : LC oscillators have been used in circuits connected to loudspeakers to create some of the sounds of electronic music. which is in the audible range of frequencies

Reviews

Write a Review

Civil Engineering Questions & Answers

  Plate with respect to the surface of the liquid will be

The plate is submerged in a liquid is a vertical position with the parallel sides horizontal and the shorter parallel side at the top and exactly in the surface of the liquid. The static moment of the plate with respect to the surface of the liqui..

  Will the vc meet minimum ssd standards if speeds limited

A particular crest vertical curve (VC) on US 280 at Shelton Mill Rd has long been criticized as being unsafe. Its length is 400 feet. The prevailing speed on the crest VC is 50 mph. In its present condition, its tangent grades are G1=2 percent and..

  Expected boiling-point elevation

What is the expected boiling-point elevation of water for a solution that contains 271 g of sodium chloride dissolved in 1.0 kg of water?

  Superelevation rate for a roadway

What superelevation rate would you recommend for a roadway with a design speed of 100 km/hr and a radius of curvature of 500 m? Assume f = 0.11.

  Percent elongation and percent reduction in area

Also, at the failure cross sections the diameters are found to be 0.731 in., 0.645 in., and 0.587 in., respectively. Determine the percent elongation and percent reduction in area of each specimen.

  Determine liquid detention time-loading rate and fm ration

Determine the liquid detention time, loading rate, F/M ration (with an MLSS of 2350 mg/l), sludge age (with 5330 lb/day waste sludge Eff. SS= 20 mg/l. Will the sludge settle properly

  Determine the molar fraction of the gas that condenses

The stream from a gas well is a mixture containing 50 mol % methane, 10 mol % ethane, 20 mol % propane, and 20 mol % n-butane. This stream is fed into a partial conderser maintained at a pressure of 250 psia

  Unit of measurement and unit of payment

Write the unit of measurement and unit of payment of following items. 1) Earthwork in excavation in foundation. 2) Framwork. 3) Steelwork in trusses. 4) Damp proof course D.P.C. 5) Cement.

  Determine what should be the diameter of each basin

A 4 mgd water treatment planet is being designed for an overflow rate of 0.5 gpm/ft^2. If two circular sedimentation basins will be used at al times, what should be the diameter of each basin

  Find what is the upward acceleration starting from rest

An elevator weigh 4000kg. When the upward tension in the supporting cable is 48000N what is the upward acceleration Starting from rest, how far does it rise in 3s

  Determine the largest feasible scale ratio for such a study

A newly designed dam is to be modeled in the laboratory. The prime objective of the general model study is to determine the adequacy of the spillway design and to observe the water velocities, elevations, and pressures at critical points of the st..

  Estimate the first derivative of f

Write a script newquot.m that uses the Newton quotient, [f (x + h) - f (x)]/h, to estimate the first derivative of f (x) = x3 at x = 1, using successively smaller values of h: 1, 10-1, 10-2, and so forth. Use a function M-file for f (x).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd