Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. A steam power plant has high and low pressures of 20 MPa and 10 kPa, respectively, and one open FWH operating at 1 MPa with the exit as saturated liquid. The maximum temperature is 800?C, and the turbine has a total power output of 5 MW. Find the fraction of the extraction flow to the FWH and the total condenser heat transfer rate.
2. A low-temperature power plant operates with R-410a maintaining-20?C in the condenser, a high pressure of 3 MPa with superheat to 80?C. There is one open FWH operating at 800 kPa with an exit as saturated liquid at 0?C. Find the extraction fraction of the flow out of the turbine and the turbine work per unit mass flowing through the boiler.
Use the consolidation data from Problem 8-20 to compute the settlement of a structure that adds 150 kPa to the already existing overhurden pressure of 120 kPa at the middle of a 6 m thick layer.
a constant head permeability test was conducted on a clean sand sample. the diameter and length of the test specimen
If the average velocities in the 0.15 m and 0.2 m diameter pipes are 2 m/s and 3 m/s respectively, then find the average velocity in the 0.3 m diameter pipe
Given the data , design a section of sanitary sewer to carry these flows at minimum velocity of 2.5 fps. Assume that the minimum depth of the sewer below the street must be 8.5 ft and that an n value of 0.013 is applicable.
The influent BOD5to a primary settling tank is 345 mg/L.The average flow rate is 0.050 m3/s.If the BOD5 removal efficiency is 30%,How many kg of BOD5 are removed in the primary settling tank each day?
What measures of performance are derived from each?
In prolonging a line by plunging the telescope between backsight and foresight, but not double centering, what angular error is introduced?
Using Buckingham-Pi method, derive a relationship to evaluate the discharge, Q, over a rectangular notch as a function of the width of notch, b, acceleration due to gravity, g, fluid density
Can it be larger than the largest gas constant in the mixture?
Select an ST shape to be used as a 20-ft long tension member to resist the following service loads: Dead load=38kips live load=115 kips and snow load= 75 kips. The connection is through the flange with 3/4inch diameter bolts in each line. Use A572 Gr..
the triangular plate ABC is supported by ball and socket joints at B and D and is held in the position shown by cables AE and CF. If the force exerted by cable AE at A is 1000N , determine the moment of the force about line joining points D and B.
A cross section of a cottage, 20 ft wide, is an isosceles triangle. If the slope of a side is 1.75 and there is a second floor 8 ft above the ground floor, what is the width of the second floor?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd