Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A rectangular copper specimen (Table 1--> E=120GPa) is loaded in tension of 300MPa and then the load is removed. The total plastic strain in the unloaded specimen is e=0.25. If the original dimensions of the specimen were w=6mm, t=2mm and l=50mm, the cross sectional area of the specimen after loading is closest.
A biological reactor is used to treat wastewater from a small community (Q = 100,000 gpd). The influent BOD5 concentration to the reactor is 200 mg/L and the required effluent BOD5 concentration is 30 mg/L.
Prepare an outline of the experimental design you will suggest to the plant manager. This outline should contain research rationale, aims and objectives, research methodology, nature of data analysis and interpretation, and possible outcomes/concl..
A flat plate weighing 220 N slides down a 15 degree incline with a velocity of 2.5 cm/sec. A thin film of oil with a viscosity of 1.29 N.sec/m^2 separates the plate from the ramp. if the plate is 50 cm by 75 cm, calculate the film thickness in cm.
The 75 lb block is released from rest 5 ft above the plate. Determine the compression of each spring when the block momentarily comes to rest after striking the plate.
If the allowable shear stress in the 7/8" diameter bolt is 35 ksi, determine the allowable force F that may be applied.
Calculations with steam mixed with additional steam at a different pressure, A steam press at 650Kpa + dryness fraction of 0.9% flows along a pipe at a rate of 3.5Kg per second
What would be the Horizontal and vertical component from this acting force see diagram
A water sample has phenolphthalein alkalinity (PPA) of 30 mg/L as CaCO3 and total alkalinity (TA) of 84 mg/L as CaCO3. If OH alkalinity is 5.3 mg/L as CaCO3, Calculate the alkalinity due to HCO3- and CO3-2.
In New york you had a balloon inflated with helium (He) and you measured its temperature, which was 89.6 degree F, and its pressure, which was 100,000 N/m^2. In Colorado, however, you noticed that the temperature of the He was 69.8 degree F and th..
Assuming a standard driver reaction time of 2.5 seconds, what is the probability that the vehicle pulling out will get in an accident with oncoming traffic?
What are the important findings in Austin Road Co. v. OSHRC and Builders Steel Co. v. Marshall? Your response should be approximately 200 - 300 words and include a reference citation for your response.
the pressure drop over 15 m of 2-cm diameter galvanized iron pipe is measured to be 60 Pa. If the pipe is horizontal, estimate the flow rate of water. use for water v=10^-6 m^2/s and density of water = 1000kg/m^3
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd