Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Find the cooling load (in tons of refrigeration) for a room supplied with 10,000 CFM of 95 DB outside air with ratio of 105 gr/lb. The room is to be maintained at 78 DB and humidity ratio of 71.5 gr/lb. The room calculated sensible heat load is 108,000 BTUH and latent load of 30,000 BTUH
The mean grade on a final examination was 72, and the standard deviation was 9. The top 10% of the students are to receive A's. What is the minimum grade a student must get in order to receive an A
The difference between the total and static pressure before a shock is 75 psi. What is the maximum static pressure that can exist at this point ahead of the shock? The gas is oxygen.
A 100ft steel tape measure correctly when supported throughout its length under a tension of 1- lb and at a temperature of 72F.It is used on the field at a tension of 18 lb and supported at the two ends only.
a spot speed study was conducted on a freeway on which the mean speed and the standard deviation were found to be 72 .4 mi/hr and 5.4 mi/hr, respectively. what is the range of the values that would be expected to contain the middle 95 percent of s..
Raw primary sludge at a solids concentration of 4% is mixed with waste activated sludge at a solids concentration of 0.5%. The flows are 20 and 24 gal/min, respectively. What is the resulting solids concentration
Calculate the required compressive strength for a concrete mix design if F'c = 5000 psi and data indicate a standard deviation of 600 psi based on 15 tests for a similar concrete mix
The ½ inch pipe was found to have an average friction factor of 0.0129 and the ¾ pipe had an average friction factor of 0.0209. The length of the pipes between the two manometer connections are 60 inches each.
A Pelton wheel located at an elevation of 200.0 m is sued to extract power from a reservoir at an elevation of 800.0 m. A penstock 1500 m long and 0.8 m in diameter connects the reservoir and nozzle of the Pelton wheel.
Determine the runoff hydrograph that would be generated by a design 3-hr storm that generates excess rainfall at a constant rate of 10 mm/hr. assume baseflow is constant at 1.0 m3/s.
Draw the shear force and bending moment diagrams for the beam, making sure to include values for the maximum positive and negative bending moments and their locations. Also determine the distance from the left hand end of the beam to the point whe..
an unconfined compression test was conducted on a cylindrical clay specimen with the following properties: Peak load at failure = 4.5lb, diameter of sample = 1.2 in.
45 ft wide, and 14 ft deep and treats 10 mgd. The power input to provide paddle-blade velocities of 1.0 and 1.4 fps for the inner and outer blades, respectively, is 930 ft'lb/s.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd