Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 60- Hz, four pole Y-connected induction motor is rated at 5 HP, 220V. The equivalent circuit parameters are
R1=0.48 ohms, X1=0.80 ohms, R2'=0.42 ohms, X2'=0.80 ohms, Xm=30 ohms
The motor is operating with slip of 0.04. Find the input current and power factor. Also find the air gap power, the mechanical power developed, and the electromagnetic torque.
one question: During each cycle, the velocity v (in mm/s) of a piston is v = 6t - 6t^2, where t is the time (in sec). Find the displacement s of the piston after 0.75 sec if the initial displacement is zero.
design an arithmetic incrementer/decrementer circuit. Your circuit will recieve a 3-bit binary number (A) as input to produce an output which is either A+1 or A-1 depending upon the command input (ID).
Assume that your application has 600 data reads for each 4000 instructions. For the same number of instruction the application has 400 data writes. The cache used has an instruction miss rate of 0.6% and a data cache miss rate of 6%.
how does Intel's architecture differ from MiPS?
Power Electronics: A Single-Phase Bridge Rectifier, A single-phase bridge rectifier has a purely resistive load R=10 Ohms, the peak supply voltage Vm=170 V
A terminated transmission line with Z0 = 60 ohm has a reflection coefficient at the load of = 0.4 60. (a) What is the load impedance (b) What is the reflection coefficient 0.3 away from the load (c) What is the input impedance at this point
Power Dissipation Problems, A signal generator outputs a sine wave signal with a frequency of 1000 Hz and an rms voltage of 20.0 V. The output of the spectrum analyzer is connected to a 200 ohm resistor.
A meter movement has a series resistance of 10-ohm and a full scale current of 100mA. Use this meter movement to design a 10A full scale ammeter. Be sure to show a schematic of your design.
Important information about Examination of a digital radio link A. A digital radio link operates at a frequency of 75 MHz and uses ideal RRC filters with nroll off factor r = 0.2 in the transmitter
A single-phase source is connected to an electric load. The load draws a 0.6 oer-unit current at 1.10 per-unit voltage while taking real power of 0.5 per-unit at a lagging power factor. Choose a base voltage of 12.47KV and a current of 100A.
A lossless line having an air dielectric has a characteristic impedance of 100 Ohms. Another line that is identical in dimensions to the air line is fabricated with the air displaced by a dielectric material have an \(\epsilon_{r}\) value of 4.
Needs to oscillate 5 times per second. Amplitude envelope increases 25% every second. Amplitude is 1 at t =0. The derivative at t = 0 is 54.6371. the sinusoid has to be a cos(2*pi*5*t) for the exponential exp(at).
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd