Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A three phase Y-connected 220-Volt 10-Hp, 60Hz, 6-pole induction motor has the following constants in Ohms per phase referred to the stator.
R1=0.294, R2=0.144, X1=0.503, X2=0.209, Xm=13.25. The total friction and core losses may be assumed to be constant at 403 Watts, independent of load. For a slip of 2% , compute the speed, output torque, and power and stator current, power factor and efficiency when the motor is operated at rated voltage and frequency.
Discuss the factors that determine transformer efficiency. What are some sources of transformer losses and how can these can be reduced
If she is a carrier, then each prince has a 50-50 chance of having hemophilia, independently of the other princes. If the queen is not a carrier, the prince will not have the disease. Suppose the queen has had three princes, each without the disea..
What is the (approximate) maximum electric field intensity for which constant mobility may be assumed for electrons in silicon. In a digital circuit with a supply voltage of 1V, what is the corresponding gate length for MOS transistors.
A permanent magnet DC motor has an armature resistance of 0.45 ohm and when a voltage of 120 V is applied to the motor it reaches a steady-state speed of rotation of 25 rev/s and draws 35 A.
Current on the surface of inner conductor is 4I going into the page (positive current flows into the page) or is in negative z direction while current on outer conductor surface is 2I in the reverse direction or positive Z- direction. I is the gen..
A three-phase ,600MVA,13.8KV Ac generator has a synchronous reactance of 2.0 per unit. The generator is connected to a system for which specified base fare 100MVA and 345KV.
A coaxial cable connects a 50W transmitter to an antenna with a feed impedance of 200W. The operating frequency is 900MHz and the cable has a velocity factor of 0.66. Determine the characteristic impedance and length of the cable.
A shunt DC motor has RA = 0.7-ohm and VT =429.6 V. For an output power of 50.4 hp, we have nm = 1,452 rpm and IA = 110.8 A. The field current remains constant for all parts of this problem. Find the rotational power loss in watts.
Write the verilog code for a circuit that counts the number of 1s in a byte. Write the verilog code using a structural approach based on four Half-Adders, two 2-bit adders and one 3-bit adder. Write the test bench code to test the design.
A unity feedback control systems for a robot submarine has a plant with a third-order transfer function G(s) = K / (s(s + 10)(s +50)) We want the overshoot to be approximately 7.5% for a step input
1. Compute the probability of having the sum of 10 by throwing (a) two dice, (b) three dice. 2. What is the probability of three of a kind for a poker hand with (a) a card deck of 52 cards, (b) a card deck of 32 cards
This bar is made of AISI 1006 cold-drawn steel and is loaded by the forces F=0.55 kN and T=25.N.m. Use both the maximum-shear theory and the distortion-energy theory to design the bar diameter D.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd