Find flow speed and depth of water above a hump

Assignment Help Civil Engineering
Reference no: EM13747157

Question 1

In a trapezoidal canal with base width of 25 m, bed slope of 0.000167, Manning's roughness coefficient of 0.025, side slope of 2:1 ( Horizontal: Vertical) and flow rate of 60m3/s:

a) determine normal depth
b) determine critical depth
c) what are Froude number and flow regime?

Question 2

Water flows uniformly at a depth y1= 40 cm in the concrete channel, which is 10 m wide. (Figure Q2). Estimate the height of the hydraulic jump that will form when a sill is installed to force it to form.( Do not take the channel as a wide canal, make reasonable assumption of required data)

1671_Find flow speed and depth of water.png

Question 3

Find flow speed and depth of water above a hump in the Figure Q3. Calculate critical depth, Froude number and draw specific energy curve. If raise hump by 0.07 how depth of water changes upstream.

1523_Find flow speed and depth of water1.png

Question 4

A floodway is designed to carry 25 m3/s of flow across a rural road. If ground slope is 0.002 and roughness coefficient 0.035, calculate width and velocity of water for wading up to the knee height. Is this floodway safe to wade? Why?

Question 5

A wide canal has a bed slope of 0.001 and carries water at a normal depth of 1.2 m. A weir is to be constructed at one point to increase the depth of flow to 2.4m.

a) How far upstream of the weir will the depth be 1.35 m? Take Manning roughness coefficient as 0.018. What is the water surface profile and why?

b) Instead of the weir a free overfall is constructed. Where upstream of the free overfall 98% of the normal depth occurs? What is the water surface profile and why?

c) In case of (b) where the EXACT normal depth occurs?

Question 6

Sketch possible water surface profiles for the channel in the Figure Q6, a, b and c. First locate and mark control points, then sketch the profiles, marking each profile with the appropriate designation. Show any hydraulic jumps that occur.

2204_Find flow speed and depth of water2.png

Reference no: EM13747157

Questions Cloud

Landscape architecture visual impact assessment on route 88 : Landscape architecture Visual impact assessment on Route 88 in the state of California utilizing the 6 steps involved in assessing the impacts of transportation project.
The level of real aggregate demand for output in a macro : Suppose the level of real aggregate demand for output in a macro economy is a negative function of the expected real interest rate- the nominal interest rate minus the expected inflation rate. Suppose also that the monetary authorities are setting th..
What was chiricos envisioned style of metaphysical : What two Modernists groups of German Expressionism emerged? What did the artists of the two groups share in style? What was Chirico's envisioned style of metaphysical?
The level of real aggregate demand for output in a macro : Suppose the level of real aggregate demand for output in a macro economy is a negative function of the expected real interest rate- the nominal interest rate minus the expected inflation rete. Suppose also that the monetary authorities are setting th..
Find flow speed and depth of water above a hump : determine normal depth, determine critical depth and what are Froude number and flow regime - Find flow speed and depth of water above a hump.
Town has two burger restaurants located across the street : A small midwest town has two burger restaurants located across the street from each other: 'Burgerama' and 'The Burger Brothers'. As both restaurants compete for the same customers, they are both considering offering a larger burger with more topping..
Identify key cultural in time periods from 1920s to present : Prepare a 10-minute Microsoft PowerPoint presentation in which you identify key cultural time periods from the 1920s to the present.
Differentiate between pancreatitis and peptic ulcer : Differentiate between pancreatitis and peptic ulcer and Compare and contrast the pathophysiology, signs, and possible complications of pancreatitis and peptic ulcer
Differentiate between pancreatitis and peptic ulcer : Differentiate between pancreatitis and peptic ulcer and Compare and contrast the pathophysiology, signs, and possible complications of pancreatitis and peptic ulcer

Reviews

Write a Review

Civil Engineering Questions & Answers

  Write expression for engineering strain associated with a

A piece of wire is stretched from length l1 to length l2 (step A), and then from length l2 to length l3 (step B). (i) Write down an expression for the engineering strain associated with step A.

  Determine the effectiveness of the regenerator

A Brayton cycle with a regenerator uses air as the working fluid. The air enters the compressor at 283K and 0.1 MPa. The highest temperature in the cycle is 1073K and the pressure ratio across the compressor is 8

  Calculate the average velocity of the flow leaving

Water enters a cylindrical tank through two pipes at rates of 250and 100 gal/min. If the level of water in the tank remains constant, calculate the average velocity of the flow leaving thetank through an 8-in. inside-diameter pipe.

  Determine whether it has an fcc or bcc crystal structure

Rhodium has an atomic radius of 0.1345nm and a density of 12.41g/cm^3. determine whether it has an FCC or BCC crystal structure.

  Develop one additional question that you think susan have

Mike and Susan hope to retire a few years early, they decided to pay closer attention to the predicted amount of retirement benefits and do some analyses on the numbers.

  Find range of values of p for which equilibrium is maintain

knowing that the coefficient of static friction between the collar and the rod is .35, determine the range of values of p for which equilibrium is maintained when 0=50deg and M=20Nm

  How to calculate the increase in weight of the tank

water flows into a weigh tank for 30 minutes. Calculate the increase in weight of the tank, if the discharge is 1.5 ft^3/s. The temperature is 50 F.

  Determine the critical load of a steel tube

Determine the critical load of a steel tube that is 5 m long and has a 100-mm outer diameter and a 16-mm wall thickness. Use E = 200 GPa.

  Compute the volume of a waste sludge with water content

Compute the volume of a waste sludge with 96% water content containing 1000 lb of dry solids. If the moisture content is reduced to 92%, what is the sludge volume

  Geometric design and construction of a new two-lane road

Geometric design and construction of a new two-lane two-way road has been recently completed and now it is time for design pavement near Ballarat, Victoria.

  Consider the steady viscous flow through a small horizontal

Consider the steady viscous flow through a small horizontal tube. for this type of flow, the pressure gradient along the tube should be a function of the dynamic viscosity, the mean velocity and the diameter of the tube. use dimensional analysis to d..

  Annual worth of the project

Use microsoft excel functions to find the net present worth of the project, and the internal rate of return,and the annual worth of the project?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd