Find diameter of the shaft for maximum rotation in a and c

Assignment Help Civil Engineering
Reference no: EM13300118

The uniform steel shaft has two gears attached to it at B and C, two frictionless bearings, and the motor. The motor generates 15kip·in and the gears consume 10kip·in and 5kip·in. Find the diameter of the shaft if the maximum rotation between A and C is 1.5°. Gsteel = 11,200ksi.

Reference no: EM13300118

Questions Cloud

How to calculate the approximate enthalpy change : The steam reforming of methane is widely used in industry to make hydrogen, as given in the following reaction:CH4(g) + H2O(g) ? CO(g) + 3H2(g) a) Calculate the (approximate) enthalpy change
Determine the current through the battery : A 5?, 10?, and 20? resistor are connected in parallel and the combination connected in parallel to a 20V battery with negligible resistance
Explain what is the concentration of pcl3 when equilibrium : The equilibrium constant Kc for the following reaction PCl3(g) + Cl2(g) PCl5(g) equals 49 at 230°C.If 0.70 mol of PCl3 is added to 0.70 mol of Cl2 in a 1.00-L reaction vessel at 230 degrees Celcius, what is the concentration of PCl3 when equilib..
Compute the rms voltage of the source : In an L-R-C series circuit, the rms voltage across the resistor is 29.4V , across the capacitor it is 89.0 V, What is the rms voltage of the source
Find diameter of the shaft for maximum rotation in a and c : The uniform steel shaft has two gears attached to it at B and C, two frictionless bearings, and the motor. The motor generates 15kip·in and the gears consume 10kip·in and 5kip·in. Find the diameter of the shaft if the maximum rotation between A an..
What maximum current can the wire handle : A wire cable is rated to have a maximum power of 308 W. If the potential difference is 110 V, what maximum current can the wire handle
Does the strategy build on current competencies : Briefly describe the strategy and why you picked it as one of the top five - Does the strategy build on current competencies and foster horizontal relationships among brands?
Explain titrate the excess potassium dichromate : If 0.5mL of .3% (mass) ethanol is oxidized with 10mL 0.005M K2Cr2O7 , what volume of 0.05M Fe(NH4)2(SO4)2.6H2O is needed to titrate the excess potassium dichromate
Determine diameter of the shaft at allowable shear stress : The steel uniform shaft has four pulleys attached to it and frictionless bearings at its ends. The pulley at B is connected to a motor that is driving the system. The other three pulleys are consuming the power delivered by Pb .

Reviews

Write a Review

Civil Engineering Questions & Answers

  Travel of particle during time period

Determine the acceleration when t = 4 s, the displacement from t = 0 to t = 10 s, and the distance the particle travels during this time period.

  Temporary change on the highway

Determine the minimum distance from the diversion that a road sign should be located informing drivers of the temporary change on the highway. The letter height on the road sign is 5 inches.

  Compute moment of the force about a line through origin

The force F = 90i + 60j + 20k acts at the point (0,0,40). Compute the moment of the force about a line through the origin that has direction cosines (1/sqrt(3), 1/sqrt(3), 1/sqrt(3), 1/sqrt(3)).

  How much of a reduction in the automobile emission

How much of a reduction in the automobile emission rate would be required to achieve the maximum eight-hour average NAAQS for CO at steady state 9ppmv (10.3 mg/m3)?

  Four-lane undivided multilane highway

A four- lane undivided multilane highway ( two lanes in each direction) has 11- ft lanes and 5- ft shoulders. At one point along the highway there is a 4% upgrade that is 0.62 mi long.

  Projectile shot vertically upward

The height (in meters) of a projectile shot vertically upward from a point 2 m above ground level with an initial velocity of 24.5 m/s is h2+24.5t-4.9t^2 after t seconds. a) When does the projectile reach its maximum height? b) What is the maximum..

  Determine the speed of the impellers in rpm

The plant is to employ alum coagulation. and pertient data for the folcculation basin are as follows: detention time = 20 min, G = 35 /sec at 50F, GT = 10000 to 100000, width = 1.25 depth, length = 2width, no baffling, number of impellers = 2

  Explain online professor''s response to probability problems

Online professor's response to: Probability problems, A very rich investor has a small amount of spare cash which she wishes to invest. She has four options to choose from.

  Determine what is the concentration of pce in the lake

An industry discharges PCE (tetrachloroethene, tetratchloroethylene, or perchloroethylene) into a small, well-mixed lake. The influent concentration is 0.4mg/L and the hydraulic residence time of the lake is 5days.

  Find coefficient of permeability of clay for loading range

A laboratory consolidation test was performed on a clayey soil specimen, which was drained on both top and bottom. The time for 50% consolidation was 6.2 minutes, and the specimen's thickness at 50% consolidation was 0.740 in.

  Solve for steady-state concentration of both compounds

Atrazine, a neutral triazine herbicide manufactured by the Ciba-Geigy group, undergoes biological and chemical decomposition to formhydroxy-atrazine. a).Assuming a pseudo first order decay constant of 0.01/day for atrazinr and 0.005/dayfor hydroxy..

  Determine what is the elevation of the point b

Long Line: the slope distance and zenith angle measured from point a to point b were 17,685.20 ftand 93degrees 13' 46" . The instrument and reflector heights were equal. If the elevation of the point A is 1854.43 ft above the MSL Datum

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd