Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 4000-m3/day conventional activated sludge plant has an influent with a BOD5 of 190 mg/L and SS of 225 mg/L. What population would this plant serve? If the primary tanks remove 60% of the SS, what volume (m3) of primary sludge at 4% solids concentration must be removed from the primary tanks each day? Assume that the waste activated sludge is not returned to the primary tanks.
If the primary tanks remove 30% of the BOD5, what MLSS (80% volatile) should be maintained in the 3 aeration tanks, each 10 m * 10 m * 3.5 m, to provide an F/M ration of 0.3 per day.
Given s=.30/(60-u), where s is the spacing (space headway) in miles, and u is the speed in miles per hour, derive the relationships u-k, u-q, and q-k. Also, estmate the capacity (qmax) of the roadway.
Discuss the different agencies, institutes, centers, different environmental companies that are active in UAE.
The section of the plywood in the 3rd quadrant is sawed off and the resulting piece is then glued squarely over the 4th quadrant portion of the plywood with glue of negligible weight.What are the x- and y-coordinates of the resulting center of gra..
The posItIon of a particle along a straight line is given by s = (t 3 - 9t 2 + 1St) ft, where t is in seconds. Determine its maximum acceleration and maximum velocity during the time interval 0 :5: t :5: 10 s.
the maximum degree of curvature can be at most 6.0 and the superelevation can be at most +6.0%. Design the ramp for the highest horizontal curve design speed given the constraints.
Describe in your own words the three strengthening mechanisms i.e., grain size reduction, solid solution strengthening, and strain hardening. Be sure to explain how dislocations are involved in each of the strengthening techniques.
Determine total delay, maximum queue length, and the time that the 20th vehicle to arrive waits from its arrival to its departure.
A 1600 ft long sag verical curve (equal tangent) has a pvc at station 1200+00 and elevation o 1500 ft. the initial grade is -3.5% and the final grade is 6.5%. determine the elevation and stationing of the low point, pvi and pvt.
The IIT components of ownership cost based on average annual value are: Tax-3%, Insurance -4%, and Interest-7%. a) What is the average annual value?
A dense sand has an effective friction angle of 43 and c'=0. A dry, 2.8-inch diameter sample is tested in drained triaxial shear with a confining pressure of 2500 psf. What axial load, P (in pounds), will be required to fail the sample?
To remove a nail, a small block of wood is placed under a crowbar, and a horizontal force P is applied as shown. Knowing that the maximum vertical force needed to extract the nail is 2600 N and that the horizontal force P is not to exceed 290 N, d..
Air can be assumed as a di-atomic ideal gas. Find the final temperature and the amount of work ( in kW) required for air compression at a rate of 100 mol/s , from an initial condition of 1 bar an 25 C to 10 bar; for the following ways:
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd