Explain what would be the expected conponent concentration

Assignment Help Chemistry
Reference no: EM13495088

50mL of 0.1M aquesous solution of some organic compound was brought in contact with 10ml of octanol at 20*C. after equilibration GC analysis of octanol phase shows component concentration of 0.4M. what would be the expected conponent concentration in octanol phase at equiliibrium if the same partitioning procedure would be performed at 60*C? (octanol/ water partitioning coefficient expressed as K= Coct/Cwater).

Reference no: EM13495088

Questions Cloud

State full and condensed ground state electronic : Write the full and condensed ground state electronic configuration and draw the orbital diagram for the following a. Gallium, Ga b. Cesium, Cs
Concept of opportunity cost : Concept of opportunity cost, explain the statement "There is no such thing as a free lunch and evaluate the statement 'The concept of opportunity cost is embedded in the demand curve'.
What angle does the ray make with the horizontal : A ray of light traveling in air enters benzene contained in a rectangular tank whose walls are made of ice. The bottom of the tank is a mirror. What angle does the ray make with the horizontal (normal) when it reaches the side of the tank
Explain which is a principal product of the reaction : Which is a principal product of this reaction. CH3OK + (CH3)3CBr ® A) CH3OC(CH3)3 B) CH2=C(CH3)2 C) CH3OCH3 D)
Explain what would be the expected conponent concentration : what would be the expected conponent concentration in octanol phase at equiliibrium if the same partitioning procedure would be performed at 60*C? (octanol/ water partitioning coefficient expressed as K= Coct/Cwater).
Determine how far up the incline will it go : A hollow cylinder (hoop) is rolling on a horizontal surface at speed 4.3 when it reaches a 11incline. How far up the incline will it go
Compute the inventory turnover ratio for fiscal year 2012 : Compute the inventory turnover ratio for the fiscal year 2012. Also compute it for the fiscal year 2011. What conclusions can you make?
Find the frequency of the wheel after the clay sticks to it : A potter's wheel is rotating around a vertical axis through its center at a frequency of 1.8. What is the frequency of the wheel after the clay sticks to it
How to evaluate the ph of the solution : A solution of dimethylamine/dimethylammonium buffer contains 0.246 M (CH3)2NH and 2.09 M (CH3)2NH2Cl. Calculate the pH of the solution. Round your answer to 3 significant digits. Kb= 5.1x10^-4 (CH3)2NH(aq) + H2O(l) = (CH3)2NH2+(aq) + OH-(aq)

Reviews

Write a Review

Chemistry Questions & Answers

  Compute the energy levels

compute the energy levels for the rotation perpendicular to its symmetry axis at J=1. T he bond length in the 14NH 3 =101.2 pm and NHN bond angle 106

  Compute the mass flow rate and power

Calculate the mass flow rate and power needed to run the compressor while assuming that oxygen can be treated as an ideal gas and that the gas at the entrance and at the exit is in local equilibrium.

  What is the ph of a solution

For H3PO4, a tripotic acid, Ka1 = 7.1 × 10-3, Ka2 = 6.3 × 10-8, and Ka3 = 4.5 × 10-13. What is the pH of a solution which contains 0.200 mol of K2HPO4 and 0.300 mol of Na3PO4 per liter of solution?

  Use the initial volume of acetic acid the volume of naoh

use the initial volume of acetic acid the volume of naoh required to reach the equivalence point and the value of the

  Compute the cost of the reactants to convert

Scale up the reaction from a 10 mL sample of WVO, 2 mL of methanol and 0.1 g DRANO. Calculate the cost of the reactants to convert one gallon of WVO into one gallon of biofuel.

  Find out the molar enthalpy change for the reaction

Using the same assumptions and approximations you used in lab, determine the molar enthalpy change (in kJ/mol) for the reaction below, assuming that CH3CO2H dissociates completely in water.

  Calculate the difference in pressure

14.0 moles of gas are in a 6.00 L tank at 22.6 C. Calculate the difference in pressure between methane and an ideal gas under these conditions.

  What is the final temperature of the block

If the aluminum block is initially at 25^C, what is the final temperature of the block after the evaporation of the alcohol? Assume that the heat required for the vaporization of the alcohol comes only from the aluminum block and that the alcohol ..

  How much heat (in kj) is evolved

How much heat (in kJ) is evolved in converting 1.00 mol of steam at 160.0 degrees Celcius to ice at -45.0 C? The heat capacity of steam is 2.01 J/g and of ice is 2.09 J/g.

  Explain how many moles of carbon dioxide can be produced

If you start with 6.00 moles of C3H8 (propane) and 6.00 moles of O2, how many moles of carbon dioxide can be produced. C3H8(g) + 5O2(g) 3CO2(g) + 4H2O(g)

  State aspirin is an organic acid with formula

Aspirin is an organic acid with formula C8H7COOH and molar mass 180.16171 g/mol. A 1.30 g tablet is titrated with 0.1500 M HCl and the endpoint is reached

  Write the structures for the major monobromination

Write the structures (or name the structures) for the major monobromination products that would be formed from each of the following substrates used. Explain your predictions.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd