Explain what is the pressure in the flask

Assignment Help Chemistry

Reference no: EM13293239

When 0.539 L of Ar at 1.20 atm and 227°C is mixed with 0.223 L of O2 at 501 torr and 127°C in a 400. mL flask at 27°C, what is the pressure in the flask?

Reference no: EM13293239

Questions Cloud

Prove that the product of a non-zero rational number : Prove that the product of a non-zero rational number and an irrational number is irrational and use a proof by cases to show that for any real numbers a, b and c, rnin(a, min(b, c)) = min(ntirt(a, b), c) .

Explain condensation polymerization reaction : What functional groups are the key players in a condensation polymerization reaction. How so.

Sketch a metering circuit including instrument transformers : A three-phase four wire 480Y /277 volt service is sized to carry 375 amperes per phase. Sketch a metering circuit,including instrument transformers, that provides line-to-neutral voltage, phase current, and kilowatt-hour metering.

Design a circuit that given a 4-bit bcd digit will produce : Design a circuit that given a 4-bit BCD digit(0-9) will produce a 2-bit quotient and a 2-bit remainder for a division by3. This circuit will have four inputs--the four bits of the BCD digit--and four outputs--2 bits for the quotient and 2 bits for..

Explain what is the pressure in the flask : When 0.539 L of Ar at 1.20 atm and 227°C is mixed with 0.223 L of O2 at 501 torr and 127°C in a 400. mL flask at 27°C, what is the pressure in the flask

What is the initial level of output per person : What is the initial level of output per person? What is the level of output per person after 10 years?

How long was the arrow in the air before striking the target : An archer lines up an arrow on the horizontal exactly dead center on a target as drawn in the figure below. How long was the arrow in the air before striking the target

Explain the hottest temperature yet recorded in phoenix az : The hottest temperature yet recorded in Phoenix AZ was 122 dgrees F what is the temperaturein degrees C and K

Determine the sending-end voltage and power factor : A 138-kV, three-phase short transmission line has a per-phase impedance of (2+j4) ohms. If the line supplies a 25-MW load at 0.8 power factor lagging, calculate (a) the efficiency and (b) the sending-end voltage and power factor.

User Account

All Pages