Explain what is the entropy change for the process

Reference no: EM13291989

For a certain process at 27°C, DG = +210.6 kJ and DH = -168.2 kJ. What is the entropy change for this process at this temperature? Express your answer in the form, DS = ____ J/K.

Reference no: EM13291989

Questions Cloud

Determine what is the sensitivity in volts per degree : A potentiometer is used to measure the position of a shaft. theinput range of shaft position is from - 160o to +160o . the corresponding output range is from -20 to +20 v. what is the span of this position sensor

Explain the standard molar entropy change for the reaction : Calculate DG0 for the reaction below. The standard molar entropy change for the reaction at 298 K is -287.5 J/mol·K.

Find direction of the magnetic force on the power line : A horizontal power line of length 52 m carries a current of 1.4 kA, find direction of the magnetic force on the power line

Design a dc power supply with an ouput voltage : design a DC power supply with an ouput voltage of 12 v from an Ac source of120 v rms and 60 HZ. the rms ripple voltage should be limited to10% of the DC output. use a load resistance of 10 KΩ

Explain what is the entropy change for the process : For a certain process at 27°C, DG = +210.6 kJ and DH = -168.2 kJ. What is the entropy change for this process at this temperature? Express your answer in the form, DS = ____ J/K.

Design a zener regulator with an output voltage : design a Zener regulator with an output voltage of 7.5 v. the supply voltage can vary between 10 v and 25 v and the load current between 10 mA and 60mA.

Describe how alignment between the values of an organization : Describe how alignment between the values of an organization and the values of the nurse impact nurse engagement and patient outcomes. Discuss how an individual can use effective communication techniques to overcome workplace challenges, encourage co..

Find how much charge resides on the outer surface : The membrane that surrounds a certain type of living cell has a surface area of 4.4 x 10-9 m2, The potential on the outer surface of the membrane is +52.2 mV greater than that on the inside surface. How much charge resides on the outer surface

Design circuit to limit output voltage of sinusoidal source : design a circuit to limit the output voltage between -5v and+5v. the input is a sinusoidal source with a peak value of 10 v and a frequency of 1KHz.

User Account

All Pages