Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Traction and Total ResistanceWould you please help me with the following question:
A 90 tonne rear dump truck travels on an 8% grade loose gravel road. Determine the traction and total resistancei. On the way up when the truck is loadedii. On the way up if the truck is empty
For the following conditions:* Rolling resistance factor = 100 kg/tonne* Coefficient of friction = 0.35* Vehicle weight empty = 700 kg/tonne of rated capacity* Gross vehicle weight = dead weight + capacity* Grade resistance factor = 10 kg/tonne* Load distribution = 33 % on front tyres and 67% on rear tyres
How to calculate the principle of shoring system in formwork analysis when the secondly floor upper has been poured?
A soil specimen has a water content of 18% and a wet unit weight of 118.5 lb/cu. ft. The specific gravity of solids is found to be 2.72. Find the:
Calculations with steam mixed with additional steam at a different pressure, A steam press at 650Kpa + dryness fraction of 0.9% flows along a pipe at a rate of 3.5Kg per second
Write a paper on steel sustainability.
Beginning whith the 1-D, steady state, general mass(volume) balance equation Qin-Qout=0 derive the 1-D poisson equation.
Wastewater is discharged into an aquifer. This wastewater contains 0.1 ppm atrazine (a common herbicide). The MCL of atrazine is 5 ppb, the density is 1.19 g/mL and the solubility is 50 ppm. 500 ft away from the plant effluent there is a permeable..
Determine the effective size as well as the uniformity coefficient and coefficient of curvature for each soil. Determine also the percentages of gravel, sand, silt, and clay according to (a) ASTM, (b) AASHTO, (c)USCS, and (d) the British Standard.
A lagoon with volume 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply
If the engine is mounted solidly on a rigid foundation, what is the alternating force amplitude transmitted? Assume the connection rod to be of infinite length.
Assuming an isotropic and homogenous hydraulic conductivity of 0.0001 cm/s what is the magnitude and direction of specific discharge (q)?
The maximum vertical load and horizontal load have been identified and shown in the figure. Under this loading condition, you are asked to determine the horizontal deflection of joint C.
Describe some of the benefits of physical models and mock-ups. What data are required to measure the following cost-effectiveness, system effectiveness, operational availability, and life-cycle cost?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd