Explain the rate of change of enthalpy of the system

Assignment Help Chemistry
Reference no: EM13662774

a. Illustrate that the rate at which shaft work is obtained or needed for a reversible change of state in a closed system at constant internal energy as well as volume is equal to the negative of the product of the temperature as well as the rate of change of the entropy for the system.

b. Illustrate that the rate at which shaft work is obtained or needed for a reversible change of state in a closed system at constant entropy as well as pressure is equal to the rate of change of enthalpy of the system.

Reference no: EM13662774

Questions Cloud

Explain if the temperature changes from 150c to 300c : Explain the can contains fewer molecules than an identical can of hydrogen gas at the same temperature and pressure for the reason that the hair spray molecules and propellant molecules are larger than hydrogen molecules.
Explain how many grams of glucose require to be burned : Explain how many grams of glucose require to be burned to heat a block of metal from 22 °C to 162 °C. Define the piece of metal has a density of 2.335 g mL-1, a specific heat of 0.508 J g-1 °C-1, also has dimensions of 1.2×4.71×1.52 cm.
State a mechanism that accounts for methylcyclope formation : Determine the reaction of 1-cyclobutylethanol 1-hydroxyethylcyclobutane with concentrated H2SO4 at 120 degrees C. State structures of all reasonable organic products. Presuming that methylcyclopentene is one product, State a mechanism that account..
Define what is the exit temperature of the steam : Steam at 35 bar and 600 K enters a throttling valve that decrease the steam pressure to 7bar. Presuming there is no heat loss from the valve, Define what is the exit temperature of the steam and its change in entropy
Explain the rate of change of enthalpy of the system : Illustrate that the rate at which shaft work is obtained or needed for a reversible change of state in a closed system at constant entropy as well as pressure is equal to the rate of change of enthalpy of the system.
How many alpha emissions occur in 25.0 minutes : State Polonium 218 is an alpha emitter with a half life of 3.0 minutes. Explain if a sample contains 55 mg of Po-218 (atomic mass = 218.008965), how many alpha emissions occur in 25.0 minutes. If the Polonium is ingested by a person to define what..
Explain how many grams of salt per of ice is needeed to make : In winter, subsequent to a snow storm, salt (NaCl) is spread to melt the ice on roads. Explain how many grams of salt per 1000. g of ice is required to make it liquid at -2.0 C? Watch sig figs you may require to use scientific notation (i.e. 3.4e2..
Explain what will be the height of the barometric column : While 760mm of Hg is taken 1atm pressure was measured. Explain what will be the height of the barometric column if this mercury is replaced by water
Explain how many grams of potassium carbonate : A flask containing 450mL of 0.500MHBr was accidentally knocked to the floor. Explain how many grams of potassium carbonate are needed to neutralize the acid according to the subsequent equation

Reviews

Write a Review

Chemistry Questions & Answers

  State concentration for isotonic solutions of other salts

An isotonic solution is described as 0.92% NaCl (g/mL). Would this also be the required concentration for isotonic solutions of other salts, such as KCl, MgCl2,

  Evaluate enthaply naoh for the solution process

A 9.55 gram sample of solid sodium hydroxide dissolves in 100.0 grams of water in a coffee-cup calorimeter, the temperate rises from 23.6 degrees Celsius to 47.4 degrees Celsius. Calculate enthaply( in kJ/mol NaOh) for the solution process.

  Explain the table of reduction potentials on the last page

Use the values from the table of reduction potentials on the last page to determine ?Gº and Keq for the reaction as listed below. Pb (s) + Sn2+ (aq) ? Pb2+ (aq) + Sn (s) ?Gº

  Calculate a value of ka for acetic acid

Using the average initial pH of your acetic acid solutions, and the average molarity of those solutions, calculate a value of Ka for acetic acid. when initial pH is 2.63 and average molarity is 0.06475.

  Explain what volumetric flow rate of fuel gas

The flue gases leave the heater at 410 F. Of the entering methane, 70% burns to carbon dioxide and 30% burns to carbon monoxide. What volumetric flow rate of fuel gas is required if there are no heat losses to the surroundings?

  Explain the rate law for the reaction

Experiment Initial Initial Initial [A], Mol/L [B], Mol/L Rate 1 0.10 0.10 1.4 x 10^2 2 0.20 0.10 2.8 x 10^2 3 0.20 0.10 5.6 x 10^2 What is the rate law for the reaction. A) rate= k [A][B] B) rate= k [A]^2[B]^2 C) rate= k [A] D) rate= k [A][B]^2 E)..

  Explain why is the nitration of aromatic rings

(Nitration of Methyl Benzoate Worksheet Lab) The nitric acid used in the experiment is greater than 90% pure nitric acid. Why does the yield decrease as the percentage of water in the nitric acid increases. Why is the nitration of aromatic rings a..

  Explain what is the molarity of the new solution

What is the molarity of the new solution. If the temperature of a sample of water requires 3.2 KJ of heat to raise the temperature from 26.1 C to 36.2 C, how much water was in the sample

  What are the differences between alkenes and alkynes what

what are the differences between alkenes and alkynes? what are the differences between cis- and trans-isomers? how are

  Define how can solvents hinder the rates of nucleophile

This question observes reactions with charged electrophiles. Define how can each of these solvents help or hinder the rates of nucleophile, such as Br-, with electrophile carrying positive charge leaving group, such as (CH3CH2)2CHOH2+

  Explain what is the pressure that is due to the helium

A gas cylinder contains only the gases radon, nitrogen, and helium. The radon has a pressure of 222 torr while the nitrogen has a pressure of 446 torr. If the total pressure inside the cylinder is 771 torr, what is the pressure that is due to the ..

  Define what percentage of the original carbon-14 will remain

The half-life of carbon-14 is 5730 years. Therefore, 5730 years after being cut from a tree, a piece of wood will have 50.0% of the carbon-14 that it had originally.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd