User Account

All Pages

Explain the best to buffer an aqueous solution at a ph

Assignment Help Chemistry
Reference no: EM13277466

Which of the following combinations would be the best to buffer an aqueous solution at a pH of 5.0? H3PO4 and H2PO4- (Ka=7.5e-3) HNO2 and NO2 (Ka=(4.5e-4) CH3CO2H and CH3COO (Ka= 1.8e-5) H2PO4 and HPO4 (Ka=6.2e-8)

Reference no: EM13277466

Questions Cloud

Compute the average power delivered to this circuit : A 3700 ? (ohm) resistor and a 1.2-µF capacitor are connected in series across a generator, Determine the average power delivered to the circuit
Evaluate the standard potential for the cell : Calculate the standard potential for this cell at 25 °C. Standard reduction potentials can be found here.
Find the fraction of time the diode is conducting : Design a half-wave rectifier as a dc power supply that delivers 0.2A and 15V peak values to a load. The ripple voltage is to be no more than 0.4V peak to peak. The rectifier is led from the voltage line (120Vrms, 60Hz) through a transformer.
What are the magnitude and direction of the total force : A charge of -3.00 nC is placed at the origin of an x-y coordinate system, and a charge of 2.00 nC is placed on the y-axis at y=4.00cm. What are the magnitude and direction of the total force
Explain the best to buffer an aqueous solution at a ph : Which of the following combinations would be the best to buffer an aqueous solution at a pH of 5.0? H3PO4 and H2PO4- (Ka=7.5e-3) HNO2 and NO2 (Ka=(4.5e-4) CH3CO2H and CH3COO (Ka= 1.8e-5) H2PO4 and HPO4 (Ka=6.2e-8)
Determine the voltage at the load terminal : The load absorbs 30 kW at 0.8 power factor lagging. The line impedance is (1.4 + j 1.6) ohms per phase between generator G1 and the load, and (0.8 + j1.0) ohms per phase between generator G2 and the load.
The helium aton in a one-dimensional box calculate the value : for a helium aton in a one-dimensional box calculate the value of the quantum number of energy level for which the energy is equal to 3/2kt at 25 degrees c for a 1nm long box
What is the probability of all three manufacturing lines : Your firm has 3 different manufacturing lines that each produce the same type of widget
Predict the spectrum-analyzer display for the signal : A spectrum analyzer is used to verify an FM signal with a carrier frequency of 100.3 MHz, a modulation frequency of 15 kHz, and a modulation index of 2.4. a.) Predict the spectrum-analyzer display for the signal

Reviews

Write a Review

Chemistry Questions & Answers

  Explain what is the ratio of c-14 in a wooden object

What is the ratio of C-14 in a wooden object made in 100 BC to the one made of the same kind of wood in 700 BC? Half life of carbon-14 is 5730 years.

  Explain compound is the oxide

Consider the molecules CsO2, Na2O, K2O2, MgO, and H2O2 and answer the questions below. If there is more than one answer, give both separated by a comma with no spaces. Order doesn't matter.

  Explain what was the molarity of the excess reactant

What mass in grams of CO2 was evolved? The balanced equation I set up is: Na2CO3 + 2HClO4 --> NaClO4 + CO2 + H2O Now what? What was the molarity of the excess reactant (HCl or Na2CO3)?

  Define what is the enthalpy of formation of c8h16o

A 1 g sample of C8H16O is burned completely in excess oxygen to yield CO2(g) and H2O(l) at 25 C, releasing 39.28 kJ of energy. What is the enthalpy of formation of C8H16O?

  Compute the equilibrium partial pressures

The following equilibrium is established: 1 H2O(g) + 1 CH4(g) ? 1 CO(g) + 3 H2(g) At equilibrium 0.03264 mol of CH4 is found in the reaction mixture. (a) Calculate the equilibrium partial pressures of H2O, CH4, CO, and H2. Peq(H2O) = . Peq(CH4) = ..

  Explain deviation from raoult''s law

If a solution is made from 100 g of pentane and 100 g of hexane, what will be the mole fraction of pentane in the gas phase over that solution (if only hexane and pentane vapor are present)? Assume no deviation from Raoult's law

  Calculate the half-life

The radioactive decay of a certain sample produced 936 disintegrations per minute. Exactly 3.00 days later, the rate of decay was found to be 511 disintegrations per minute. Calculate the half-life, in days, for the decay of this sample.

  Find important information about chem problem

Important information about Chem problem, A 25 mL sample of .13M HCl is mixed with 15mL of .24M NaOH. The pH of the resulting solution will be nearest. The answer is 11.9

  State the effect on calculated concentration of naoh

what would be the effect on your calculated concentration of NaOH, if, unbeknownst to you, someone left the KHP out and it absorbed water?

  Compute the molar solubility of iron sulfide

Calculate the molar solubility of iron sulfide in a solution that is saturated with hydrosulfuric acid, H2S ( [H2S] = 0.1 M) and has a pH of 2.0. Ka1 = 8.9 x 10^-8 and Ka2 = 1.2 x 10^-13.

  Define the k value for compound z in this biphasic system

what is the K value for compound Z in this biphasic system, (2) how much do you remove in each individual extraction, (3) how much of compound Z is extracted with those three 33.3 mL extractions added together, AND (4) how much is still in the wat..

  What volume of carbon dioxide measured at stp

What volume of carbon dioxide measured at STP will be formed by the reaction of 1.43 mole of oxygen with 0.900 mole of ethyl alcohol?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd