Explain the average pressure in the column

Assignment Help Chemistry
Reference no: EM13228155

A saturated liquid mixture consisting of 60% propane, 30% n-butane, and 10% n-pentane is to be separated into an overhead product that contains 98% of the propane that enters with the feed. The bottom product is to contain 95% of the n-butane in the feed. The average pressure in the column is 689 kPa.

a). What is the minimum number of stages required for this separation? Determine the distribution of n-pentane at this condition.

b). Solve for the minimum reflux ratio. Solve for both Class1 and Class 2 separations.

c). If a reflux ratio 1.5 x Rmin is used, how many theoretical stages are required for a Class 2 separation in b).

d). Estimate the feed stage location.

Reference no: EM13228155

Questions Cloud

Depict the standard line notation for each cell : Write the standard line notation for each cell below. Assume all concentrations are 1.0 M and all partial pressures are 1.0 atm. IO3-(aq) + Fe2+(aq) --> Fe3+(aq) + I2(aq)
What is the after-tax investment value of the machine : A corporation purchased a machine for $60,000 five years ago. It had an estimated life of 10 years and an estimated salvage value of $9,000. The current book value of this machine is $22,500. If the current market value is $40,000.
Explain and balance an equation : Complete and balance an equation describing each of the above reactions. (Use the lowest possible coefficients. Omit states-of-matter in your answer.)
Explain what is the equivalent uniform annual cost : Machine A was purchased three years ago for $10,000 and had an estimated market value of $1,700 at the end of its 10-year life. Annual operating costs are $1,350. The machine will perform satisfactorily for the next seven years.
Explain the average pressure in the column : The bottom product is to contain 95% of the n-butane in the feed. The average pressure in the column is
What is the saturation current and surface leakage current : A silicon diode has a reverse current of 5 uA and 25 degrees celcius and 100uA at 100 degrees celcius. What is the saturation current and surface leakage current at 25 degrees celcius
Analysis of the organisation using the metaphors : Select an organisation of your choice and critically analyse it using two different metaphors. You should present your organisational analysis in a written essay.
Explain a different substitution reaction that should yield : None of the desired ether was obtained. What product was formed and why did this route to the ether fail? Suggest a different substitution reaction that should yield the desired product.
Write formula for the magnetization volume current density : Write the formula for the magnetization volume current density J M and magnetization surface current density JMS in terms of magnetization vector M. 4. A sphere has permanent magnetization where is a positive constant.

Reviews

Write a Review

Chemistry Questions & Answers

  What is the enthalpy of combustion

What is the enthalpy of combustion (in kJ/mol) for acetone (CH3COCH3) under standard conditions (water is produced as a liquid)? Use the appendix in your textbook, do not enter units, and answer with 5 significant digits.

  Explain the ionization constant for hclo

Calculate the pH for each of the following cases in the titration of 50.0 mL of 0.240 M HClO(aq) with 0.240 M KOH(aq). The ionization constant for HClO can be found here (4.0×10-8).

  What is its volume at standard pressure and temperature

if a gas occupies a volume of 5 L at 546 K and 2.5 atm, what is its volume at standard pressure and temperature.

  Explain the ph of a solution that results from diluting

What is the ph of a solution that results from diluting .30 mol acetic acid and .20 mol sodium acetate with water to a volume

  How much gas will dissolve

if 0.55 g of a gas dissolves in 1.0 l of water at 20.0 kPa of pressure, how much will dissolve at 110.0 kPa of pressure?

  Explain what is the mass of the copper block

When the two substances reach thermal equilibrium, the final temperature is 24.2 degrees celcius. What is the mass of the copper block?

  Compute the ph at the equivalence point barbituric acid

Calculate the pH at the equivalence point if 25.00 mL of 0.010 M barbituric acid (HC4H3N2O3) is titrated with 0.20 M NaOH

  Illustrate the acid-catalyzed dehydration of an alcohol

Why do you suppose that the dehydration of cyclohexanol to cyclohexene has been the tradiotional experiment to illustrate the acid-catalyzed dehydration of an alcohol to an alkene?

  Explain what are the values of kp and kc

One mole of CO29(g) is mixed with one mole of H2 (g) and passed over a catalyst for the following reaction: CO(g)+2H2(g)=CH3OH(g) At 500 K and a total pressure of 100 bar, 0.40 mol of CH3OH is gounf at equilibrium. What are the values of Kp and Kc?

  Define what is the specific heat of the alloy

The temperature of the water rose t oa final temperature of 27.84 C. Neglecting heat loss to the room and the heat capacity of the beaker itself, what is the specific heat of the alloy?

  State the total concentration of enzyme in the reaction

The total concentration of enzyme in the reaction was 10 mmol/mL. What is thekcat (K2) of this reaction?

  Explain what mass of oxygen is contained in the two tanks

Assuming a tank temperature of 16oC, what mass of oxygen is contained in the two tanks?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd