Explain splitting patterns and integrations may be used more

Assignment Help Chemistry
Reference no: EM13266544

Construct a simulated 1H NMR spectrum, including proton integrations, for CH3OC(CH2OCH3)3. Drag the appropriate splitting patterns to the approximate chemical shift positions; place the integration values in the small bins above the associated chemical shift. Splitting patterns and integrations may be used more than once, or not at all, as needed. Likewise, some bins might remain blank. Note that peak heights are arbitrary and do not indicate proton integrations.

Reference no: EM13266544

Questions Cloud

Obtain the maximum acceleration : A simple harmonic oscillator with m = 0.740kg and total energy E = 125J has amplitude 1.65m, Find the maximum acceleration
Explain sketch the titration curve for carbonic acid h2co3 : Sketch the titration curve for carbonic acid H2CO3. Plot pH on the ordinate axis and relative equivalents of base added on the abscissa axis. Using this figure, indicate what the major species of the carbonate buffe
Obtain the particles speed : A particle with a mass of 7.43 multiply.gif 10-27 kg has a de Broglie wavelength of 8.37 pm. What is the particle's speed
Explain the approximate chemical shift positions : Construct a simulated 1H NMR spectrum, including proton integrations, for CH3CHCl2. Drag the appropriate splitting patterns to the approximate chemical shift positions; place the integration values in the small bins above the associated chemical s..
Explain splitting patterns and integrations may be used more : Splitting patterns and integrations may be used more than once, or not at all, as needed. Likewise, some bins might remain blank. Note that peak heights are arbitrary and do not indicate proton integrations.
Determine the net force acting on wire : Determine the net Force (magnitude and direction) acting on wire 3 due to wires 1 and 2 for currents of 10A. Each wire has a horizontal length of 50 cm and each wire is seperated by a distance of 2 cm
Define structure that corresponds to the following molecular : Give the structure that corresponds to the following molecular formula and 1H NMR spectrum: C7H16O:
Estimate the cost per kwh of an alkaline d-cell : Battery-powered electricity is very expensive compared with that available from a wall receptacle. Estimate the cost per kWh of an alkaline D-cell
Define what ph is needed such that the maximum : What pH is needed such that the maximum [Mg^(2+)] in solution is 2x10^-4 M given the equilibrium: Mg(OH)2(s) Mg^(2+) + 2OH^(-)

Reviews

Write a Review

Chemistry Questions & Answers

  Explain polyvinyl alcohol strands can form hydrogen bonds

PVA (polyvinyl alcohol) strands can form hydrogen bonds between different parts of the same strand. Illustrate how this can occur by using a sketch to show the hydrogen bonding.

  Explain the differences in properties and triethylamine

Triethylamine, (ch3ch2)3n, is a liquid that boils at 89C and has a viscosity of about 4 x10^-4 kg/ms. Explain the differences in properties of these two componds.

  Explain the volume of methane

The heat combustion of ch4 is 890.4 the heat capacity of h20 is 75.2. find the volume of methane measured at 298k and .690atm reauired to convert

  Define ratio of the masses of the buffer components

Which of the following buffer systems would be the best choice to create a buffer with the pH= 9.00? For the best system , calculate the ratio of the masses of the buffer components required to make the buffer.

  Solving equilibrium problem to calculate the ph

Solve an equilibrium problem (using an ICE table) to calculate the pH of each solution:a solution that is 0.165M in HC 2 H 3 O 2 and 0.120M in KC 2 H 3 O 2.

  Explain a mixture conntains two compound that absorbs

a mixture conntains two compound that absorbs strongly in the 300-600nm range the molar absorptivities of the two compounds at two wavelenghts in this range are shown in the table compound molar absorptivity at 400 nm mola..

  State what is the pressure of the gas

If the barometric pressure is 741 mmHg, and if h = 53. 0 mm, what is the pressure of the gas, expressed in atm and in kilopascals, if the substance in the tube is mercury having a density of 13.6 g/mL.

  Depict the structures of the trans-cycloalkanes

Draw the structure(s) of the trans-cycloalkanes with the chemical formula C7H14 that contain a 5-membered ring.

  State what is the ph of a buffer prepared by adding the acid

What is the pH of a buffer prepared by adding 0.45 mol of the waek acid HA to 0.608 mol of NaA in 2.00 L of solution? The dissociation constant Ka of HA is 5.66e-7

  Determine what would be its temperature after absorption

Determine what would be its temperature after absorption of 9.4 * 10-2 kWh of heat If 1.45 L of water is initially at 25.0 °C,?

  What is the boiling point of the solution

What is the boiling point of the solution produced by adding 363 g of ethylene glycol (molar mass = 62.1 g/mol) to 1.5 kg of water? For each mole of nonvolatile solute, the boiling point of 1 kg of water is raised 0.51°C.

  What the following molar ratios should be

Given the following equation: 2 C4H10 + 13 O2 ---> 8 CO2 + 10 H2O, show what the following molar ratios should be.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd