Explain purpose and amount of reinforcing in concrete beams

Assignment Help Civil Engineering
Reference no: EM13314264

Simply Supported Reinforced Concrete Beams - Explain the purpose and amount of reinforcing in concrete beams in relation to bending and shear and the concepts of under reinforcement, balanced reinforcement and over reinforcement. Explain also the reason for ensuring ductility in beams, and the purpose of ensuring that the proportion of tensile steel to the cross sectional area of the beam falls between a minimum and a maximum value.

Reference no: EM13314264

Questions Cloud

Find what is the minimum radius of curvature for a curve : The coefficient of friction between a car's tires and the road is such that the car can generate a maximum deceleration of 1.1g without experiencing slip.
Find the total internal energy of the system : A cylinder contains 2.15 mol of helium gas at 22.5°C. Assume that the helium behaves like an ideal gas. Find the total internal energy of the system
What would be the reading on a barometer containing benzene : What would be the reading on a barometer containing Benzene at 20 degrees Celsius at a time when the atmospheric pressure was equivalent to 12.3 m of water
How to calculate q of the fraction of solute : Calculate q, the fraction of solute that would remain in the water under each of the following extraction conditions: Three extractions with 100 mL of ether.
Explain purpose and amount of reinforcing in concrete beams : Simply Supported Reinforced Concrete Beams - Explain the purpose and amount of reinforcing in concrete beams in relation to bending and shear and the concepts of under reinforcement, balanced reinforcement and over reinforcement.
What is theshear modulus of the sponge : A large sponge has forces of magnitude 12 N applied in oppositedirections to two opposite faces of area 42 cm^2. What is theshear modulus of the sponge
What will the lowest dissolved oxygen concentration : A wastewater is discharged to a stream with a reoxygenation constant of 0.5 day-1 and a velocity of 1 m/sec. The oxygen saturation concentration in the stream is 11 mg/L.
What are the dimensions of the image on the screen : The dimensions of the picture on a 35.0{\rm mm} color slide are x = 24.0{\rm mm} {\times}y = 36.0{\rm mm}. What are the dimensions of the image on the screen
Explain what is the change in energy : What is the change in energy, Delta E, in kilojoules per mole of hydrogen atoms for an electron transition from n=9 to n=2

Reviews

Write a Review

Civil Engineering Questions & Answers

  Explain what is the cost breakdown structure

What is the cost breakdown structure(CBS)? What are its purposes? What is included (or excluded)? How does it relate to a work breakdown structure (WBS)?

  Determine what would the deflection be at the right end

A 2-inch by 2-inch solid steel beam (18 inches long) is fixed to the wall at the left to resist applied moment (20,000 lbs-inch). What would the deflection be at the right end Up or down

  Determine the fine grains of low plasticity

Soil A is micaceous with an average grain relative density of 2.80, and has a high plasticity in its fine fraction. The ground quartz-feldspathic B is, with an average relative density of 2.65 and fine grains of low plasticity.

  Determine the magnitude of force f2 and the angle

Two ropes are attached to the eye bracket. The resultant force R of the two forces equals 1000-lb and the line of action is directed along the x-axis. if the magnitude of force F1 is 250-lb, determine the magnitude of force F2 and the angle

  What are the important findings

What are the important findings in Austin Road Co. v. OSHRC and Builders Steel Co. v. Marshall? Your response should be approximately 200 - 300 words and include a reference citation for your response.

  What type of contract would you want and why

If you were asked to perform an excavation contract competitively with limited data, what type of contract would you want and why?

  Determine the size of the beam with the least cross-section

A simple beam of Douglas-Fir Larch, select grade, has a span of 18 ft with two concentrated loads of 3 kips each placed at the third points of the span. Neglecting its own weight, determine the size of the beam with the least cross-section

  Consolidation ratio of the soil at the unloaded condition

An increment of vertical stress of150kpa compress the sample to a void ratio of1.43. What is the over consolidation ratio of the soil at the unloaded condition.

  What fraction of the herbicide is adsorbed

The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3.

  Determine the temperature rise that will cause joint to fail

the block is fitted between the fixed supports. if the glued joint can resist a maximum shear stress of T(allow)=2ksi, determine the temperature rise that will cause the joint to fail. Take E= 10(10^3)ksi, v=0.2

  Determine void ratio and unit dry weight of soil particles

A 110 cm^3 sample of wet soil has a mass of 106 g and a degree saturation of 100%. When oven-dried, the mass is 81 g. Determine the 1) water content, 2) specific gravity, 3) void ratio, and unit dry weight of soil particles.

  Determine the service rate for six vehicles per minute

Vehicles begin to arrive at a toll booth at eight vehicles per minute from 9 A.M. to 10 A.M. The booth opens at 9:10 A.M. and services at a rate of ten vehicles per minute until 9:40 A.M. From 9:40 A.M. until 10 A.M.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd