Explain how many more units of ph change

Assignment Help Chemistry
Reference no: EM13211555

Compared to each of the four buffer systems, how many more units of pH change did you observe in the distilled water upon the addition of 0.5 mL 0.1 M HCl? (I observed a 6.97 drop.) What can you conclude from these results? -- Need 4 of them because I'm lost. Also, how can I estimate the useful range of a pH meter?

Reference no: EM13211555

Questions Cloud

Explain what is the initial mole of aniline : What is the initial mole of Aniline? what is the initial mole oh HNO3 if 40mL of the acid was used in the titration
Explain a concentration cell contains electrodes : A concentration cell contains electrodes made of the same metal and solutions containing the same ions but at different concentrations.
Explain how many amps are required to produce : How many amps are required to produce 59.2 g of aluminum metal from a sample of molten aluminum fluoride
State every ten rounds an amplification of approximately : every ten rounds an amplification of approximately 1000-fold. So, to get an amplification of 4.000 one would do 2 + 10 = 12 rounds . This, of course, assumes high yields for each step.
Explain how many more units of ph change : What can you conclude from these results? -- Need 4 of them because I'm lost. Also, how can I estimate the useful range of a pH meter?
Explain what range of magnetic field strength : What range of magnetic field strength would be required to cover the mass range between 16 and 625, for singly charged ions, if the accelerating voltage is held constant?
Evaluate the molarity of a solution : Calculate the molarity of a solution of 25.2mL of methanol combined with enough water to make 622mL of solution (density of methanol is 0.79180g/mL).
Find out the kinds of intermolecular forces : Determine the kinds of intermolecular forces that are present in each element or compound.
Explain a synthetic detergent : Lauryl alcohol, C12H25OH, is prepared from coconut oil; it is used to make sodium lauryl sulfate, a synthetic detergent. What is the molality of lauryl alcohol in a solution

Reviews

Write a Review

Chemistry Questions & Answers

  State a naoh soln of unknown concentration was standardized

A NaOH soln of unknown concentration was standardized against KHP. It took 45.78 mL of NaOH soln to completely titrate 1.256 g of KHP. Cal the molarity of NaOH.

  Depict a graph that shows the relative energy

Draw a graph that shows the relative energy of the conformer as a function of the torsional angle. Make sure that you clearly label which conformer corresponds to which position on the graph.

  Explain what is the mass of the piece of metal

density of 9.14g/cm^3 is placed in a 30.0mL cylinder. Water level rises to 34.5mL. what is the mass of the piece of metal?

  Explain a tap water sample is to be analyzed for nickel

A tap water sample is to be analyzed for nickel at the ppm level, which method would yield accurate results with the least amount of sample preparation?

  Compute the ph after the amounts of naoh

Calculate the pH after the following amounts of NaOH are added. A) 0mL NaOH added( before the titration started)

  Calculate the total kinetic energy of the gaseous mixture

A 100.-L flask contains a mixture of methane, CH4, and argon at 25C. The mass of argon present is 228 g and the mole fraction of methane in the mixture is 0.650. Calculate the total kinetic energy of the gaseous mixture.

  Find out the initial and final pressures within the reactor

dissociate into two NO2 molecules if one mole of pure N2O4 is introduced to a 10 liter constant volume, constant temperature of 298K reactor. In addition determine the initial and final pressures within the reactor and the composition of the equil..

  What is the partial pressure of argon

what is the partial pressure of helium? If the two flasks are connected through a stopcock and the stopcock is opened, what is the partial pressure of argon?

  What is the molar solubility of pbso4

The Ksp for PbSO4 = 2.53 X 10-8. What is the molar solubility of PbSO4 in a 4.20M solution of gallium sulfate?

  Explain students synthesized a new compound

In a laboratory experiment, students synthesized a new compound and found that when 14.10 grams of the compound were dissolved in 208.0 grams of ethanol, the solution began to boil at 78.9510C

  What is the boiling point of a mixture composed

What is the boiling point of a mixture composed of 85 g HOCH2CH2OH (ethylene glycol) and 125 g H2O? The boiling point elevation constant for H2O is 0.512 °C/m.

  State solution depends on the number of particles

Since the freezing point of a solution depends on the number of particles, what would you expect the freezing point of 0.1 m solutions of aqueous NaCL and BaCl2?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd