Explain heating a with hydrazine in base gave hydrocarbon c

Assignment Help Chemistry
Reference no: EM13229559

Compound A, C11H12O, which gave a negative Tollens test, was treated with LiAlH4, followed by dilute acid, to give compound B, which could be resolved into enantiomers. When optically active B was treated with CrO3 in pyridine, an optically inactive sample of A was obtained. Heating A with hydrazine in base gave hydrocarbon C, which, when heated with alkaline KMnO4, gave carboxylic acid D. Identify compounds A, B, and C.

Reference no: EM13229559

Questions Cloud

Write a brief explanation about why the directors : Write a brief explanation about why the directors' duty to prevent insolvent trading exists and the circumstances and consequences of the ‘veil of incorporation' being lifted for insolvent trading.
Estimate the irradiance on the pv module facing south : The global radiation at the solar noon on a summer solstice in Albuquerque, New Mexico (latitude 35° N) is 60mw/cm^2. Assume that (a) 30 % of this irradiance is diffuse radiation and (b) the ground surrounding a PV module is non-reflecting
State oxidized to an optically inactive dicarboxylic acid c : With aqueous H2CrO4, compound A was oxidized to an optically inactive dicarboxylic acid C, C6H10O4. Give structures for compounds A, B, and C; do not specify stereochemistry.
Design full-wave bridge rectifier circuit to deliver 10volts : Design a full-wave bridge rectifier circuit to deliver 10 volts de with less than 0.1 volt (pp) ripple into a load draWing up to 10mA. Choose the appropriate ac input voltage. assuming 0.6 volt diode drops.
Explain heating a with hydrazine in base gave hydrocarbon c : When optically active B was treated with CrO3 in pyridine, an optically inactive sample of A was obtained. Heating A with hydrazine in base gave hydrocarbon C, which, when heated with alkaline KMnO4, gave carboxylic acid D. Identify compounds A, B..
Explain causes of difference between the emitted radiation : Compare this spectral distribution with that of the radiation received on the surface of the earth at AM1.5. Briefly explain the causes of the difference between the emitted radiation of the core of the sun and the received radiation at the earth'..
Explain the proton nmr spectrum of compound d : Ozonolysis of C followed by treatment with Zn and water gives CH3CHO and compound D (C9H10O). The proton NMR spectrum of compound D is given below. Treatment of compound D with ethyl magnesium bromide yields A. Draw the structures of compounds A, ..
What are earnings as a percentage of the final retail price : In the electronics business, mark-up is in the order of 100% to 130% at each level of middleman. Let's say that it is 100%. Let's further say that your product passes through three levels of middleman, that your product is produced in accordance
Explain how to recover the increased design cost : a cost to produce, P, of $4.00. If we were able to reduce this to $3.55 through greater attention in the design, and if the cost to improve the design (in NRE) is $35,000, how many units must we sell to recover the increased design cost

Reviews

Write a Review

Chemistry Questions & Answers

  Explain what is the difference between selectivity

What is the difference between selectivity and sensitivity as these words pertain to sensors? Why or why not would you want a very sensitive sensor?

  Explain original concentration of solution

To calculate the concentration of protein is it 10/990 or 10/1000? And does the original concentration of solution even matter when calculating the solution concentration?

  State process the volume of the balloon changes

A hot air balloon is inflated to its full extent by heating the air inside it. In the final stages of this process the volume of the balloon changes from 4.00 x 10^6 L to 4.50 x 10^6 L by addition of 1.3 x 10^8 J of energy as heat.

  What is the final volume

A 81 L sample of dry air cools from 145C to -22C while the pressure is maintained at 2.85 atm. What is the final volume?

  What is the change in chemical potential of any pure liquid

What is the change in chemical potential of any pure liquid when it vaporizes at its normal boiling point

  Calculate the molar heat of combustion of liquid methanol

If the mass of water surrounding the calorimeter was exactly 1000 g and the heat capacity of the bomb calorimeter was 1.75 kJ/°C, calculate the molar heat of combustion of liquid methanol .

  Compute the morality of a solution made by dissolving

Calculate the morality of a solution made by dissolving 0.750 grams of Na2 SO4 in enough water to form exactly 850 mL of solution. How many moles of KMnO4 are present in 250 mL of a 0.0475 M solution?

  Compute the temperature at which the equation

Calculate the temperature (K) at which the equation as written is at equilibrium. Express your answer to three significant figures.

  What is the vapor pressure of a solution

At 20 degrees celsius the vapor pressure of ethanol is 45 torr and the vapor pressure of methanol is 92 torr. what is the vapor pressure at 20 degrees celsius of a solution prepared by mixin 26.0 g. of methanol and 85 g. of ethanol?

  Compute the amount of the excess reagent

For the given reaction, 2 HCl (aq) + Ba(OH)2 (aq) BaCl2 (aq) + 2 H2O (l) 73.0 grams of HCl are allowed to react with 342 grams of BaCl2.

  Combustion studies of the use of h2 as an alternative fuel

In combustion studies of the use of H2 as an alternative fuel, HO is sometimes formed in flames by the reaction, H(g) + 1/2 O2(g) HO(g) Use the data below to calculate the value of Kc

  Describe the activity coefficients for acetic acid

The activity coefficients for acetic acid and the acetate ion are 1.000 and 0.775, respectively, in a solution with an ionic strength of 0.10 M.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd