Explain element and compound and homogeneous mixture

Assignment Help Chemistry
Reference no: EM13272727

Classify each of the following as an element, compound, homogeneous mixture, or heterogeneous mixture.

1.silver ingot
2.silver ore
3.silver oxide
4.silver alloy

Reference no: EM13272727

Questions Cloud

Explain if an artificial heart is capable of pumping : If an artificial heart is capable of pumping at least 57,000,000 pints of blood before failure, how long, in years, will it probably last in a patient whose average heart rate is 72 beats per minute and an average stroke volume (the amount of bloo..
Construct the circuit diagram of a decade counter : Decade counter: A decade counter is a counter circuit that counts from 0 to 9 (from 0000 to 1001 in binary numbers) and then resets. Using a 4-bit ripple counter block, 2 inverters and a 4-input AND gate, construct the circuit diagram of a decade ..
Summarize the plot of the play in terms : What is the setting of the play, in terms of the time period, region and weather? Explain the condition of the house. What emotional response does the setting evoke in you?
Write down am signal and sketch resulting am signal waveform : Consider the message signal m(t) = 20 cos(2πt) and the carrier signal c(t) = 50 cos(100πt). Write down the AM signal, and sketch the resulting AM signal waveform for 75 percent modulation.
Explain element and compound and homogeneous mixture : Classify each of the following as an element, compound, homogeneous mixture, or heterogeneous mixture.
Determine the tranfer function of the thermocouple : During calibration, and iron/constantan thermocouple is zeroed( set to emit a Zero Voltage) AT 0 DEGREES CELCIUS. At 750 degrees celcius, it emits a voltage of 38.8mV. Alinear Out/input relationships exists between 0 and 750 degrees celcius.
Compute the length of the rod : A thin uniform rod (mass = 1.95 kg) swings about an axis that passes through one end of the rod, What is the length of the rod
Plot in time of 4 periods approximate signals using 81 terms : The periodic signal x(t) is dened in one period as x(t) = te^-t; 0
Explain effect would placing a charged group in the interior : What effect would placing a charged group in the interior of a protein have on its conformational stability

Reviews

Write a Review

Chemistry Questions & Answers

  What are the concentrations of hso4-

What are the concentrations of HSO4-, SO42-, and H+ in a 0.27 M KHSO4 solution? (Hint: H2SO4 is a strong acid; Ka for HSO4- = 1.3 10-2.).

  State what is the pressure of the gas

If the barometric pressure is 741 mmHg, and if h = 53. 0 mm, what is the pressure of the gas, expressed in atm and in kilopascals, if the substance in the tube is mercury having a density of 13.6 g/mL.

  Find out the percent wo in the ceramic sample

The resulting W3 was transferred to 500.0 mL of 1.00 M HCl. A 100.00 mL aliquot of the HCl solution required 10.02 mL of 0.09352 M potassium permanganate (KMnO4) to reach the purple endpoint. A blank required 0.13 mL. Balance the reaction below an..

  How to correct for the partial of water vapor

Explain how to correct for the partial of water vapor when calculating the partial pressure of a dry gas is collected over water?

  Which receives or loses no heat from or to the surrounding

A system that had work done on it but which receives or loses no heat from or to the surroundings has

  Calculate the heat released

calculate the heat released when 176g of water at 23.0 degrees celsius are converted to ice at -10.0 degrees celsius?

  By what test could you identify the non-aqueous layer

If toluene(density 0.87) were used to extract ethylene bromohydrin (density 2.41) from an aqueous solution.

  Compute the molar mass of the biomolecule

A 1.80 g sample of a large boimolecule was dissolved in 18.0 g of carbon tetrachloride. The boiling point of this solution was determined to be 77.85°C. Calculate the molar mass of the biomolecule.

  What is the highest percent yield of n2 that can be expected

During studies of the reaction below, 2 N2H4(l) + N2O4(l) ? 3 N2(g) + 4 H2O(g) a chemical engineer measured a less-than-expected yield of N2 and discovered that the following side reaction occurs

  A glycerol solution was treated to convert into formic acid

A glycerol solution weighing 153.2 mg was treated with 50.0 mL of 0.0899 M Ce4+ in 4M HClO4 at 60 degrees C for 15 min to convert glycerol into formic acid: C3H8O3 + 8Cefourplus + 3H2O ----> 3HCO2H + 8Cethreeplus + Fethreeplus

  Compute the ph at the equivalence point in titrating

Calculate the pH at the equivalence point in titrating 0.100 M solutions of each of the following with 0.034 M NaOH. (c) sodium hydrogen chromate (NaHCrO4)?

  Explain what is the concentration of the resulting solution

8.0 mL of 10.0 ppm fe 2+ solution is diluted to 100.o ml. What is the concentration (in ppm) of the resulting solution?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd