Experiences a constant horizontal acceleration

Assignment Help Mechanical Engineering
Reference no: EM13705879

An object of mass 10 kg, initially at rest, experiences a constant horizontal acceleration of 4 m/s^2 due to the action of a resultant force applied for 20 s. Determine the total amount of energy transfer by work in kJ.

Reference no: EM13705879

Questions Cloud

Work required for compression and final pressure of gas : A gas is contained in a piston of 5 m3 at 100 KPa. Then the gas is compressed till its volume is reduced to 2.5 m3. If there was no exchange of heat from the system during the compression process, calculate the work required for the compression and t..
Determine the work for the process with the value : A gas in a piston-cylinder assembly undergoes an expansion process for which the relationship between pressure and volume is given by pV^n = constant. The initial pressure is 4.25 bar, the initial volume is 0.25 m^3 and the final volume is 0.55 m^3.
Money was made in interest over the initial investment : If a single deposit of $25000 is invested at 1.75% yearly interest, what equal year-end withdrawals can be made each year for 10 years, leaving nothing in the fund after the 10th withdrawal? How much money was made in interest over the initial invest..
What is the new gage pressure : The gage pressure in an automobile tire when measured during winter at 32 o F was 32 psig. The same tire was used during the summer when the temperature rose to 112 o F. If we assume that the volume of the tire did not change, and no air leaked out b..
Experiences a constant horizontal acceleration : An object of mass 10 kg, initially at rest, experiences a constant horizontal acceleration of 4 m/s^2 due to the action of a resultant force applied for 20 s. Determine the total amount of energy transfer by work in kJ.
Determine the amount of jet fuel consumed during take off : A jumbo jet with a mass of 5 million kg requires a speed of 175 mph for takeoff. Assuming an overall efficiency of 20% (from heat release to kinetic energy of the aircraft), determine the amount of jet fuel (heating value: 44 MJ/kg) consumed during t..
Equation of motion for the initial conditions : Find the response of systems governed by the following equation of motion for the initial conditions x(0)=1, xdot(0)=-1:
Piston cylinder arrangement has an impeller protruding : A piston cylinder arrangement has an impeller protruding through the wall so that mechanical work can be done on the system. The piston weighs 15 lbf and is a circular disk with a diameter of 4 inches. The cylinder contains 1lbm of air initially at 5..
Calculate the pressure difference between inside and outside : Tall buildings can develop a significant difference in pressure between the inside and the outside of the building. Air lock entrances are used at the ground level so the pressure at the ground floor is not the same as atmospheric pressure. Assume th..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Compare the minimum theoretical rate and the actual rate at

at steady state. a power cycle generates 100 mw of electricity while discharging energy by heat transfer at a rate of

  Its surface temperature is 230 0c and the ambient air

a large fireplace in a ski lodge has a glass firescreen which covers a vertical opening in the fireplace. the opening

  Basically find dhdt and allow a value of h to be plugged

consider a thin walled cylindrical tank having a diameter of 2 ft and a height of 5 ft. the tank is initially filled to

  A piston-cylinder device contains steam initially at 1 mpa

a piston-cylinder device contains steam initially at 1 mpa 450degc and 2.5 m3. steam is allowed to cool at constant

  Heat transfer coefficient h64 wm2k one end of the rod is

a steel rod with a diameter of 2 cm length l25cm thermal conductivity of 50 wmk is exposed to ambient air at 20c. heat

  A container of air with a fixed volume of 1 ft3develops a

a container of air with a fixed volume of 1 ft3develops a slow leak. the container originally is at 900 degrees at

  It supplies heat to a room at a rate of 46000 btuhr in

a heat pump has a second law efficiency of of 74. it supplies heat to a room at a rate of 46000 btuhr in order to

  Te plants heat source is a large furnace operating at

a steam power plant operates near a river triver27degc. and uses the river as a temperature reservoir into which it

  How much work was done on the roof by the forces

In 1975 the roof of Montreal's Velodrome, with a weight of 360 kN, was lifted by 10 cm so that it could be centered. How much work was done on the roof by the forces making the lift?

  The cross-sectional area at the top of the sprue 800 mm2

the flow rate of liquid metal into the downsprue of a mold 1 ls. the cross-sectional area at the top of the sprue 800

  Draw the system with any indicated work and heat transfer

a rigid well-insulated tank contains 3 kg of a 2-phase liquid-vapor mixture of water initially at 200 kpa with a

  Determine a the rate of heat loss from the compressor b the

consider an r-134a compressor on a refrigeration system. if the refrigerant enters as saturated vapor at 200 kpa 0.03

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd