Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A structural element subjected to cyclic loading is made of fc' = 3000 psi concrete. Compressive stresses are changing between 2200 psi and 1600 psi. The frequency of loading is 8 Hz. After 10 years of uninterrupted loading, evaluate damage of material, compressive strength and modulus of elasticity.
In New york you had a balloon inflated with helium (He) and you measured its temperature, which was 89.6 degree F, and its pressure, which was 100,000 N/m^2. In Colorado, however, you noticed that the temperature of the He was 69.8 degree F and th..
A cylindrical metal specimen 12.0 mm in diameter and 120 mm long is to be subjected to a tensile stress of 40 MPa . at this stress level the resulting deformation is totally elastic.
The 800 mm diameter shaft is made of A-36 steel. If it is subjected to the uniform distributed torque of 5kN*m/m, determine the angle of twist of end A with respect to B.
The coefficients of kinetic friction between the blocks and the inclined plane are a=0.1,b=0.3. Neglect the mass of the link. Angle between the inclined plane and the surface is 30 degree.
determine the maximum horizontal distance that a projectile will have at a height of 60 m above the orgin if it is fired at an angle at 70 degrees from the horizontal with a velocity of 50 m/s
A balloon is to be used to carry meteorological instruments to an elevation of 15,000 ft where the air pressure is 8.1 psia. The balloon is to be filled with helium, and the material from which it is to be fabricated weighs 0.01 lbf/ft^2.
Determine the deflection of a simple uniformly loaded beam by the Ritz method,using first one term, then two terms, adn finally three terms in a sine series. Why does the coefficient of sin2piex/L vanish?
Lab studies have shown that the rate constant associated with the process are as follows: k = 0.95 mg COD/mg VSS-day; Y = 0.48 mg VSS/ mg COD, half-saturation K = 85 mg COD/L; ke = 0.07 d-1.
Assume excavation costs at $100/m3, side lining costs at $50/m2, and cover cost at 25/m2. Determine the dimensions of the pit that minimize cost -If the side slope is unconstrained and -If the side slope must me less than 450
You have two wires connected end to end. Wire 1 is copper and wire 2 is made using a special carbon conductor. Wire 1 has a resistance of 0.215 ohms/ft and is 500 ft long. Wire 2 has a resistance of 0.141 ohms/ft and is 700 ft long.
The slope distance between two points is 72.665 m, and the difference in elevation between the points is 1.120 m. Compute the horizontal distance.
A square plate of uniform thickness has a side length of 25 cm that hangs vertically from hinges at its top edge, When horizontal jet strikes the plate at its center, the plate is deflected and comes to rest at an angle of 30o to the vertical.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd